Holder C Generation 2000 series

Manual transmission fluid capacity & service interval

Holder C Generation 2000 series uses manual transmission fluid with a capacity range of 4,25 to 12,5 liters. Service intervals include checking at 150 hours and changing at 1350 or 1500 hours or 12 months. The data covers 13 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
C 760 (1994-2001)
  • Use: Normal
  • Capacity 7,1 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
  • C 760 (1994-2001)
  • With creeper group
  • Use: Normal
  • Capacity 8,4 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
C 770 (1994-2001)
  • Use: Normal
  • Capacity 7,1 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
  • C 770 (1994-2001)
  • With creeper group
  • Use: Normal
  • Capacity 8,4 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
C 770H (1994-2001)
  • Use: Normal
  • Capacity 9,6 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
C 860 (1994-2001)
  • Use: Normal
  • Capacity 7,9 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
  • C 860 (1994-2001)
  • With creeper group
  • Use: Normal
  • Capacity 9,2 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
C 860F (1994-2001)
  • Use: Normal
  • Capacity 11,2 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
  • C 860F (1994-2001)
  • With creeper group
  • Use: Normal
  • Capacity 12,5 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
C 870 (1994-2001)
  • Use: Normal
  • Capacity 7,9 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
  • C 870 (1994-2001)
  • With creeper group
  • Use: Normal
  • Capacity 9,2 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
C 870H (1994-2001)
  • Use: Normal
  • Capacity 10,4 liter
  • Check 150 hours
  • Change 1350 hours/ 12 months
  • Code: 12/4
C 30 (1990-1994)
  • Use: Normal
  • Capacity 4,25 liter
  • Check 150 hours
  • Change 1500 hours/ 12 months

Additional Notes

  • The Holder C Generation 2000 series manual transaxle fluid capacities span a wide range across models, from 4.25 liters in the C 30 up to 12.5 liters in the C 860F equipped with a creeper group. These figures represent service fill volumes, meaning the amount of fluid required during a standard drain-and-refill service rather than a full overhaul with complete disassembly.
  • The C 30 (1990-1994) carries a 4.25-liter transaxle capacity, which is notably lower than all 1994-2001 models in the lineup. The C 30 also follows a longer change interval of 1500 hours or 12 months, compared to the 1350-hour interval shared by every subsequent model in the series.
  • All models from 1994-2001 share a uniform fluid check interval of 150 hours under normal use conditions, as does the C 30. Regular level checks at 150-hour intervals are standard practice for manual transaxles in equipment operating across varied terrain and load cycles.
  • The creeper group is an additional low-speed gear reduction assembly. On the C 760 and C 770 (1994-2001), adding a creeper group raises the transaxle fluid capacity from 7.1 liters to 8.4 liters, reflecting the additional internal volume introduced by the extra gear set.
  • The same capacity increase pattern applies to the C 860 and C 870 (1994-2001), where the standard transaxle holds 7.9 liters and the creeper group configuration requires 9.2 liters. The 1.3-liter difference is consistent across both models.
  • The C 860F (1994-2001) has the largest transaxle fluid capacities in the series. Without a creeper group, the capacity is 11.2 liters, and with a creeper group, 12.5 liters. The 1.3-liter addition from the creeper group mirrors the pattern seen in the C 860 and C 870.
  • The C 770H (1994-2001) carries a 9.6-liter transaxle capacity, while the C 870H holds 10.4 liters. The H designation in both cases corresponds to higher fluid volumes compared to their non-H counterparts, the C 770 at 7.1 liters and the C 870 at 7.9 liters, indicating a more substantial internal transmission assembly.
  • All specifications across the full 1990-2001 range are listed under normal use conditions. The change interval expressed as hours or months, whichever comes first, is a standard dual-trigger format used in equipment servicing to account for machines that accumulate hours quickly as well as those used infrequently where fluid degradation over time still necessitates replacement.

Other Systems