Holder C

Manual transmission fluid capacity & service interval

Holder C manual transmission fluid capacity ranges from 6,25 to 7,85 liters. Service intervals include checking at 150 hours and changing at 1000 to 1350 hours. The data covers 12 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
C 440 4WD (1990- )
  • Use: Normal
  • Capacity 6,25 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 8/4
  • C 440 4WD (1990- )
  • With creeper group
  • Use: Normal
  • Capacity 7,85 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 8/4
C 5000 4WD (1990- )
  • Use: Normal
  • Capacity 6,25 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 12/4
  • C 5000 4WD (1990- )
  • With creeper group
  • Use: Normal
  • Capacity 7,55 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 12/4
C 5000 Turbo 4WD (1990- )
  • Use: Normal
  • Capacity 7,55 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 12/4
C 560 Turbo 4WD (1990- )
  • Use: Normal
  • Capacity 6,25 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 8/4
  • C 560 Turbo 4WD (1990- )
  • With creeper group
  • Use: Normal
  • Capacity 7,55 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 8/4
C 660 4WD (1990- )
  • Use: Normal
  • Capacity 6,25 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 12/4
  • C 660 4WD (1990- )
  • With creeper group
  • Use: Normal
  • Capacity 7,55 liter
  • Check 150 hours
  • Change 1350 hours
  • Code: 12/4
C 65 Turbo (1986-1990)
  • Use: Normal
  • Capacity 6,25 liter
  • Check 150 hours
  • Change 1000 hours
  • Code: 8/4
C 50 Turbo (1983-1990)
  • Use: Normal
  • Capacity 6,25 liter
  • Check 150 hours
  • Change 1000 hours
  • Code: 12/4
C 500 (1982-1990)
  • Use: Normal
  • Capacity 6,3 liter
  • Check 150 hours
  • Change 1000 hours
  • Code: 8/4

Additional Notes

  • Across the Holder C series, manual transaxle fluid capacities fall within a relatively narrow band, ranging from 6,25 liters to 7,85 liters depending on the variant and whether a creeper group is fitted.
  • The creeper group, an additional low-speed gear reduction assembly, increases fluid capacity in every model where both configurations are listed. On the C 440 4WD, the standard transaxle holds 6,25 liters while the creeper group variant requires 7,85 liters, the highest capacity figure across all listed configurations.
  • The C 5000 4WD and C 560 Turbo 4WD both show a creeper group capacity of 7,55 liters, as does the C 660 4WD, while the C 5000 Turbo 4WD lists 7,55 liters for its standard transaxle without a creeper group variant entry.
  • The C 500 (1982-1990) carries a standard transaxle capacity of 6,3 liters, a slight deviation from the 6,25-liter figure shared by several other models in the range.
  • A fluid level check interval of 150 hours applies uniformly across all listed configurations, regardless of model, year, or whether a creeper group is present.
  • The change interval differs between model generations. The C 50 Turbo (1983-1990), C 500 (1982-1990), and C 65 Turbo (1986-1990) all specify a 1000-hour drain interval, while all 4WD models introduced from 1990 onward carry a longer 1350-hour change interval.
  • The extended 1350-hour change interval on the 1990 4WD models represents a 35 percent increase over the 1000-hour interval specified for the earlier non-4WD variants, suggesting a difference in fluid volume, system design, or manufacturer reassessment between the two generations.
  • All specifications are expressed in operating hours rather than calendar time or distance, which is standard practice for agricultural and utility machinery where annual mileage is not a meaningful service metric.

Other Systems