Cupra Formentor, KM
Transfer case fluid capacity & service interval
The Cupra Formentor, KM uses transfer case fluid with a capacity ranging from 0.75 to 0.89 liter or 0.8 liter depending on the configuration. The data covers two configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
|
|
|
|
Additional Notes
- The Cupra Formentor KM transfer case fluid specifications cover two distinct drivetrain configurations, each with its own noted component terminology and capacity value.
- The 2.0 TDI 110 kW 4Drive variant, described in the specifications as an angle gearbox or transferbox, carries a fluid capacity range of 0.75 to 0.89 liters under normal use conditions, indicating a fill tolerance rather than a single fixed volume.
- A capacity range rather than a single fixed figure typically reflects variation between drain-and-refill service fills and the unit's total internal volume, meaning the actual accepted quantity depends on the fill method and component orientation during service.
- The 2.5 TSI 287 kW 4Drive VZ5 PF variant, described as a bevel gear transferbox, carries a fixed capacity of 0.8 liters under normal use conditions, which falls within the range specified for the 2.0 TDI configuration despite the two units being mechanically distinct assemblies.
- Both configurations are rated under normal use conditions, meaning the capacity figures apply to standard operating environments rather than severe-duty cycles.
- The differing component descriptions across the two variants, angle gearbox versus bevel gear, reflect fundamentally different internal gear arrangements, which accounts for the separate capacity entries rather than a shared specification.