Cupra Formentor, KM

Brake fluid capacity & service interval

Cupra Formentor, KM uses brake fluid with a capacity of 1,15 liters. The service interval for the fluid is 24 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Formentor VZ 390 2.5 TSI (287 kW) 4Drive VZ5 PF (2021- )
  • Use: Normal
  • Capacity 1,15 liter
  • Change 24 months
  • Formentor 1.5 eTSI (110 kW) PF (2020- )
  • ABS
  • Use: Normal
  • Capacity 1,15 liter
  • Change 24 months
  • Formentor 1.5 TSI (110 kW) PF (2020- )
  • ABS
  • Use: Normal
  • Capacity 1,15 liter
  • Change 24 months
Formentor VZ 310 2.0 TSI (228 kW) 4DRIVE PF (2020- )
  • Use: Normal
  • Capacity 1,15 liter
  • Change 24 months

Additional Notes

  • The Cupra Formentor, KM carries a brake fluid capacity of 1.15 liters across all four listed configurations, covering the 1.5 TSI, 1.5 eTSI, VZ 310 2.0 TSI, and VZ5 2.5 TSI variants.
  • A 1.15-liter figure represents a service fill quantity, meaning the amount used when topping up or replacing fluid within an intact, assembled hydraulic system rather than during a full component overhaul.
  • All four configurations specify a 24-month change interval under normal use conditions, meaning the fluid replacement cycle is time-based rather than mileage-based.
  • The 1.5 TSI (110 kW) and 1.5 eTSI (110 kW) variants note coverage of the hydraulic brake and clutch system alongside ABS, while the VZ 310 and VZ5 entries reference only the hydraulic brake system without a clutch system notation.
  • The VZ5 2.5 TSI (287 kW) 4Drive configuration, introduced from 2021, shares the same 1.15-liter capacity and 24-month interval as the earlier 2020 variants despite carrying a substantially higher power output of 287 kW.

Other Systems