Cupra Ateca, KH7/ KHP

Transfer case fluid capacity & service interval

Cupra Ateca, KH7/ KHP transfer case fluid capacity is 0,75-0,89 liter. Service intervals include normal use. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Ateca 2.0 TFSI Cupra 4Drive (221 kW) PF (2020- )
  • Bevel gear
  • Use: Normal
  • Capacity 0,75-0,89 liter
  • Ateca 2.0 TSI 4Drive PF (2020- )
  • Angle gearbox
  • Use: Normal
  • Capacity 0,75-0,89 liter
  • Ateca 2.0 TFSI Cupra 4Drive (221 kW) PF (2018-2020)
  • Bevel gear
  • Use: Normal
  • Capacity 0,75-0,89 liter

Additional Notes

  • The Cupra Ateca 2.0 TFSI Cupra 4Drive (221 kW) PF covering the 2018-2020 period carries a transfer case fluid capacity of 0.75-0.89 liter under normal use conditions.
  • A capacity expressed as a range rather than a fixed value typically reflects fill-level variation during a service fill, where fluid is added until it reaches the correct level rather than poured to a precise measured volume.
  • The 2020-onward variant of the 2.0 TFSI Cupra 4Drive (221 kW) PF shares the same 0.75-0.89 liter capacity range and normal use condition as the 2018-2020 version, indicating no change in transfer case fluid volume between the two production periods.
  • Both the 2018-2020 and 2020-onward 2.0 TFSI Cupra 4Drive variants are noted as bevel gear, transferbox configurations, which describes the mechanical layout of the unit receiving the fluid.
  • The 2020-onward 2.0 TSI 4Drive PF is identified as an angle gearbox / transferbox configuration, distinguishing the unit type from the bevel gear designation used on the 221 kW TFSI variants, even though the fluid capacity range of 0.75-0.89 liter under normal use remains identical across all three rows.

Other Systems