Lindner Geotrac 3

Power steering fluid capacity & service interval

Lindner Geotrac 3 power steering fluid capacity ranges from 16 to 32 liters. Service intervals include checking at 250 hours and changing at 1000 hours. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Geotrac 103 (2004- )
  • System, power steering
  • Use: Normal
  • Capacity 32 liter
  • Check 250 hours
  • Change 1000 hours
  • Geotrac 73 (2004- )
  • System, power steering
  • Use: Normal
  • Capacity 16 liter
  • Capacity 17 liter (Hydraulic tank)
  • Check 250 hours
  • Change 1000 hours
  • Geotrac 83 (2004- )
  • System, power steering
  • Use: Normal
  • Capacity 16 liter
  • Capacity 17 liter (Hydraulic tank)
  • Check 250 hours
  • Change 1000 hours
  • Geotrac 93 (2004- )
  • System, power steering
  • Use: Normal
  • Capacity 16 liter
  • Capacity 17 liter (Hydraulic tank)
  • Check 250 hours
  • Change 1000 hours

Additional Notes

  • The Lindner Geotrac 3 series integrates the power steering circuit within the shared hydraulic system, meaning the capacity figures listed cover the combined hydraulic and power steering volume rather than a dedicated steering reservoir alone.
  • The Geotrac 103 carries a single hydraulic system capacity of 32 liters, which is notably larger than the capacities listed for the other variants in the series.
  • The Geotrac 73, 83, and 93 each list two capacity values: 16 liters and 17 liters designated specifically for the hydraulic tank. The distinction between the two figures on the same variant suggests a difference between total system fill and the hydraulic tank portion alone.
  • All four variants share identical service intervals under normal use conditions, with a fluid level check specified at every 250 hours of operation.
  • The fluid change interval across all variants is set at 1000 hours under normal use, which is a relatively extended interval typical of tractor hydraulic systems operating under standard working conditions.
  • The 250-hour check interval represents four inspection points before a single 1000-hour change interval is reached, indicating a maintenance schedule structured around frequent monitoring rather than frequent replacement.
  • The Geotrac 73, 83, and 93 share identical capacity specifications despite being distinct model designations, pointing to a common hydraulic system architecture across those three variants starting from 2004.

Other Systems