Lindner Geotrac

Power steering fluid capacity & service interval

Lindner Geotrac power steering fluid capacity ranges from 9 to 30 liters. Service intervals include checking at 250 and 500 hours, and changing at 1000 hours or 12 months. The data covers 5 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Geotrac 100 (1999- )
  • System, power steering
  • Use: Normal
  • Capacity 30 liter
  • Check 250 hours
  • Change 1000 hours
  • Geotrac 50 (1997- )
  • System, power steering
  • Use: Normal
  • Capacity 9 liter
  • Check 500 hours
  • Change 1000 hours/ 12 months
  • Geotrac 60 (1997- )
  • System, power steering
  • Use: Normal
  • Capacity 9 liter
  • Check 500 hours
  • Change 1000 hours/ 12 months
  • Geotrac 70 (1997- )
  • System, power steering
  • Use: Normal
  • Capacity 16 liter
  • Check 500 hours
  • Change 1000 hours/ 12 months
  • Geotrac 80 (1997- )
  • System, power steering
  • Use: Normal
  • Capacity 16 liter
  • Check 500 hours
  • Change 1000 hours/ 12 months

Additional Notes

  • The Lindner Geotrac power steering function is integrated into the hydraulic system across all listed models, meaning a single fluid reservoir serves both the hydraulic and steering circuits simultaneously.
  • The Geotrac 100 carries the largest hydraulic/power steering fluid capacity in the lineup at 30 liters, which reflects the greater fluid volume demands of a higher-output tractor platform.
  • The Geotrac 50 and Geotrac 60 share an identical 9-liter capacity, along with matching check and change intervals of 500 hours and 1000 hours/12 months respectively.
  • The Geotrac 70 and Geotrac 80 share a 16-liter capacity, placing them in a middle tier between the 9-liter and 30-liter configurations found in the other models.
  • The Geotrac 100 has a fluid check interval of 250 hours, which is half the 500-hour check interval specified for the Geotrac 50, 60, 70, and 80 models.
  • The Geotrac 100 specifies a change interval of 1000 hours with no calendar-based alternative, whereas the Geotrac 50, 60, 70, and 80 all carry a dual-condition change interval of 1000 hours or 12 months, whichever comes first.
  • The 12-month calendar limit on the Geotrac 50, 60, 70, and 80 means that fluid age alone can trigger a change even when the hourly threshold has not been reached, a relevant factor for tractors with low annual operating hours.
  • All five models list normal use as the operating condition for the stated intervals, indicating the specifications apply to standard working environments rather than elevated-stress or severe-duty conditions.

Other Systems