Lindner Geotrac

Manual transmission fluid capacity & service interval

Lindner Geotrac uses manual transmission fluid with a capacity range of 22 to 34 liters. Service intervals include checking at 250 hours and changing at 1000 hours. The data covers 5 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Geotrac 100 (1999- )
  • Use: Normal
  • Capacity 34 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: 16/16
Geotrac 50 (1997- )
  • Use: Normal
  • Capacity 22 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: 16/8
Geotrac 60 (1997- )
  • Use: Normal
  • Capacity 22 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: 16/8
Geotrac 70 (1997- )
  • Use: Normal
  • Capacity 29 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: 16/8
Geotrac 80 (1997- )
  • Use: Normal
  • Capacity 29 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: 16/8

Additional Notes

  • The Lindner Geotrac 100 carries the largest manual transaxle fluid capacity in the lineup at 34 liters, reflecting the greater internal volume associated with higher-output tractor drivetrains.
  • The Geotrac 50 and Geotrac 60 share an identical transaxle fluid capacity of 22 liters, placing them in the same fill class despite being distinct model designations introduced from 1997.
  • The Geotrac 70 and Geotrac 80 both specify a 29-liter transaxle capacity, positioning them between the smaller 22-liter and larger 34-liter configurations within the range.
  • All five configurations share a uniform fluid check interval of every 250 hours under normal use conditions, indicating a consistent monitoring schedule across the model range regardless of capacity differences.
  • The fluid change interval for every configuration is set at 1000 hours under normal use conditions, meaning four check cycles occur for every full drain-and-fill service.
  • The 1000-hour change interval is expressed in operating hours rather than calendar time, which is standard practice for agricultural machinery where annual usage varies considerably between operators.
  • All specifications apply to normal use conditions, meaning no separate severe-duty intervals are listed for any of the five Geotrac transaxle configurations covered here.

Other Systems