Goldoni Maxter series
Differential fluid capacity & service interval
Goldoni Maxter series differential fluid capacity ranges from 9,5 to 10,55 liters. Service intervals include a 50 hour check and an 800 hour change. The data covers 3 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
|
|
|
|
|
|
Additional Notes
- The Goldoni Maxter 60 (ZA6300) with VM D703 engine carries a front differential fluid capacity of 9.5 liters, a figure consistent with a service fill rather than a full overhaul volume.
- The Maxter 60 RS (ZS6300), also fitted with the VM D703 engine, shares the same 9.5-liter front differential capacity as the standard Maxter 60, along with identical check and change intervals.
- Both the Maxter 60 and Maxter 60 RS specify a fluid level check at 50 hours of operation under normal use conditions, which in service interval terms refers to typical working loads without sustained extreme stress.
- The change interval for the front differential on both the Maxter 60 and Maxter 60 RS is set at 800 hours under normal use, a relatively extended drain period reflecting the lower contamination rate expected in standard operating conditions.
- The Maxter W70RS REV (ZER4), equipped with the turbocharged VM D703-TI engine, carries a front differential fluid capacity of 10.55 liters, which is notably higher than the 9.5-liter figure seen in the non-turbocharged variants.
- The 10.55-liter capacity of the Maxter W70RS REV front differential represents an increase of just over 1 liter compared to the Maxter 60 and Maxter 60 RS, a difference that likely reflects a larger or differently configured differential housing suited to the higher-output engine.
- Despite the capacity difference, the Maxter W70RS REV follows the same 50-hour check and 800-hour change intervals as the other Maxter series variants listed, all under normal use conditions.