Goldoni Maxter series

Clutch fluid capacity & service interval

Goldoni Maxter series uses clutch fluid with a capacity range between min and max. Service intervals include a 10 hour check and a 24 month change. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Maxter 60 (ZA6300), VM D703
  • Use: Normal
  • Between min and max.
  • Check 10 hours
  • Change 24 months
Maxter 60 RS (ZS6300), VM D703
  • Use: Normal
  • Between min and max.
Maxter W70RS REV (ZER4), VM D703-TI
  • Use: Normal
  • Between min and max.
  • Check 10 hours
  • Change 24 months

Additional Notes

  • All three configurations in the Goldoni Maxter series listed here use a hydraulic clutch system, meaning clutch engagement is controlled through fluid pressure rather than a mechanical cable linkage.
  • The fluid level specification across all three configurations is expressed as a range rather than a fixed volume, with the reservoir kept between the minimum and maximum marks rather than filled to a precise capacity figure.
  • The Maxter 60 (ZA6300) with VM D703 engine carries a 10-hour inspection interval for clutch fluid level, a notably short check frequency consistent with early-hours monitoring during initial operation or routine field use on agricultural equipment.
  • The same Maxter 60 (ZA6300) specification also includes a 24-month change interval, meaning the fluid is replaced on a calendar basis regardless of hours accumulated.
  • The Maxter W70RS REV (ZER4), fitted with the turbocharged VM D703-TI engine, shares the same 10-hour check interval and 24-month change interval as the Maxter 60 (ZA6300), despite the difference in engine specification between the two configurations.
  • The Maxter 60 RS (ZS6300) with VM D703 engine lists only the between-minimum-and-maximum level specification, with no check interval or change interval stated in the row specifications.

Other Systems