Goldoni Euro series

Coolant capacity & service interval

Goldoni Euro series coolant capacity is 7 liters. Service intervals include checks every 10 hours and changes every 24 months. The data covers 8 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Euro 40 A, Lombardini LDW1503
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Euro 40 RS, Lombardini LDW1503
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Euro 40 SN, Lombardini LDW1503
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Euro 45 A, Lombardini LDW1603
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Euro 45 A, Lombardini LDW1603
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Euro 45 R, Lombardini LDW1603
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Euro 45 RS, Lombardini LDW1603
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Euro 45 SN, Lombardini LDW1603
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months

Additional Notes

  • The Goldoni Euro series cooling system capacity is 7 liters across all listed configurations, covering the Euro 40 variants with the Lombardini LDW1503 engine and the Euro 45 variants with the Lombardini LDW1603 engine. A 7-liter figure for a cooling system of this class represents a full system fill, encompassing the engine block, cylinder head passages, and radiator volume rather than a partial top-up quantity.
  • The LDW1503 and LDW1603 are three-cylinder liquid-cooled diesel engines from Lombardini's LDW series. Despite the displacement difference between the two engine codes, both share an identical 7-liter cooling system capacity across all Euro 40 and Euro 45 trim variants listed.
  • The check interval of 10 hours applies uniformly under normal use conditions across all listed configurations. In agricultural and compact utility equipment, a 10-hour check interval reflects the relatively short operating cycles typical of field machinery, where coolant level and condition can change more rapidly than in on-road vehicles.
  • The change interval is set at 24 months for all listed configurations under normal use conditions. A time-based interval rather than an hours-based one for coolant replacement is standard practice, as coolant additives degrade through chemical processes over time regardless of engine operating hours.
  • The Euro 40 series covers three trim designations — A, RS, and SN — all paired with the Lombardini LDW1503 engine, and all share identical cooling system specifications. The Euro 45 series covers four trim designations — A, R, RS, and SN — all paired with the Lombardini LDW1603, again with uniform cooling system specifications across trims.

Other Systems