Kymco MXU

Automatic transmission fluid capacity & service interval

Kymco MXU automatic transmission fluid capacity ranges from 0,5 to 0,6 liters. Service intervals include 300 km and 4000 km or 12 months. The data covers 2 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
MXU 300 (2007- )
  • Use: Normal
  • Capacity 0,6 liter (Dry fill)
  • Capacity 0,5 liter (Service fill)
  • Change 4000 km/ 12 months
MXU 300 (2007- )
  • Use: Initial service
  • Capacity 0,6 liter (Dry fill)
  • Capacity 0,5 liter (Service fill)
  • Change 300 km

Additional Notes

  • The Kymco MXU 300 automatic transmission carries two distinct capacity figures: 0.6 liter for a dry fill and 0.5 liter for a service fill. The dry fill figure applies when the transmission is completely empty, such as after a full overhaul or component replacement, while the service fill figure reflects the smaller volume needed when residual fluid remains in the system after a standard drain.
  • Under normal use conditions, the MXU 300 automatic transmission fluid change interval is set at 4,000 km or 12 months, whichever comes first. The dual-trigger format means time elapsed can mandate a change even when mileage accumulation is low.
  • An initial service interval of 300 km is specified for the MXU 300 automatic transmission, separate from the normal use schedule. At that early interval, the same capacity values apply: 0.6 liter dry fill and 0.5 liter service fill.
  • The gap between the initial service interval of 300 km and the subsequent normal interval of 4,000 km is considerable. The early change at 300 km is a common practice in powertrain break-in procedures, intended to remove metal particles and contaminants generated during initial component wear-in before the regular long-term schedule begins.

Other Systems