Ausa Multitask

Manual transmission fluid capacity & service interval

Ausa Multitask manual transmission fluid capacity is 2,7 liters. Service intervals include 50 hours and 500 hours. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

Type	Specifications
M150M	Use: Normal Capacity 2,7 liter Change 500 hours
M150M	Use: Initial service Capacity 2,7 liter Change 50 hours
M150MC	Use: Normal Capacity 2,7 liter Change 500 hours
M150MC	Use: Initial service Capacity 2,7 liter Change 50 hours
M250M	Use: Normal Capacity 2,7 liter Change 500 hours
M250M	Use: Initial service Capacity 2,7 liter Change 50 hours

The Ausa Multitask manual transmission holds 2.7 liters of fluid across the M150M, M150MC, and M250M variants, a capacity consistent with a service fill rather than a full overhaul or dry fill.
Under normal use conditions, the manual transmission fluid change interval is set at 500 hours for all three variants.
An initial service interval of 50 hours applies to the M150M, M150MC, and M250M, which is one-tenth of the standard 500-hour normal interval. Initial service intervals are typically used to flush out metal particles and contaminants generated during the break-in period of new mechanical components.
The 2.7-liter capacity figure is identical across the M150M, M150MC, and M250M, indicating a shared or dimensionally equivalent transmission unit among all three configurations.
Both the normal and initial service entries for each variant share the same 2.7-liter capacity, meaning the fluid volume required does not differ between a routine drain-and-fill and the early break-in service.