Ausa Multitask

Clutch fluid capacity & service interval

Ausa Multitask uses clutch fluid with a capacity of 0,25 liter. The service interval for the fluid is 500 hours. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
M150M
  • Use: Normal
  • Capacity 0,25 liter
  • Change 500 hours
M150MC
  • Use: Normal
  • Capacity 0,25 liter
  • Change 500 hours
M250M
  • Use: Normal
  • Capacity 0,25 liter
  • Change 500 hours

Additional Notes

  • The Ausa Multitask M150M, M150MC, and M250M all share a hydraulic clutch system with a fluid capacity of 0.25 liter, which is a small reservoir volume typical of a hydraulic actuator circuit rather than a transmission or wet clutch bath.
  • The 0.25 liter capacity across the M150M, M150MC, and M250M indicates a service fill specification, meaning the figure reflects the working fluid volume held within the hydraulic clutch circuit under normal operating conditions.
  • A change interval of 500 hours applies to the hydraulic clutch fluid on all three configurations under normal use conditions, placing scheduled fluid replacement on an operating-hour basis rather than a calendar or mileage cycle.
  • The 500-hour interval tied to normal use conditions on the M150M, M150MC, and M250M reflects the demands of equipment that accumulates service time through continuous or repeated operation, where fluid degradation is measured in engine or machine hours.
  • The M150M and M150MC share identical clutch fluid specifications in both capacity and change interval, with the MC designation representing a variant that does not alter the hydraulic clutch system requirements relative to the standard M150M.

Other Systems