Valtra (Valmet) X series

Differential fluid capacity & service interval

Valtra (Valmet) X series differential fluid capacity ranges from 6 to 8 liters. Service intervals include checking at 500 hours and changing at 1000 hours. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • X100 Hitech (2000-2005)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 500 hours
  • Change 1000 hours
  • Code: Carraro
  • X105 (2000-2005)
  • Front
  • Use: Normal
  • Capacity 8 liter
  • Check 500 hours
  • Change 1000 hours
  • Code: Dana
  • X110 Hitech (2000-2005)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 500 hours
  • Change 1000 hours
  • Code: Carraro
  • X115 (2000-2005)
  • Front
  • Use: Normal
  • Capacity 8 liter
  • Check 500 hours
  • Change 1000 hours
  • Code: Dana
  • X120 Hitech (2000-2005)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 500 hours
  • Change 1000 hours
  • Code: Carraro
  • X95 (2000-2005)
  • Front
  • Use: Normal
  • Capacity 8 liter
  • Check 500 hours
  • Change 1000 hours
  • Code: Dana

Additional Notes

  • The Valtra (Valmet) X series front differential fluid capacities split into two distinct values across the model range: 6 liters for the Hitech variants (X100, X110, and X120) and 8 liters for the non-Hitech variants (X95, X105, and X115).
  • The 6-liter capacity on the Hitech models reflects a front differential housing design specific to that trim, while the 8-liter capacity on the standard models indicates a larger front differential assembly requiring a greater fluid volume to achieve a proper service fill.
  • All six models share an identical check interval of 500 hours under normal use conditions, meaning fluid level verification is due at the halfway point between each full drain-and-fill service.
  • The change interval of 1000 hours applies uniformly across all X series variants listed here under normal use conditions, placing front differential fluid changes on a relatively long-cycle schedule typical of agricultural equipment operating in controlled field environments.
  • The hour-based service intervals used across the X series are standard for agricultural tractors, where engine hours logged on the hour meter serve as the primary measure of wear and service need rather than distance or calendar time.
  • The separation between the 500-hour check and the 1000-hour change interval allows for fluid condition and level monitoring at the midpoint of the service cycle, which can indicate seal wear or contamination before the scheduled drain.

Other Systems