Valtra (Valmet) T2 Versu

Coolant capacity & service interval

Valtra (Valmet) T2 Versu coolant capacity is 30 liters. Service intervals include checks every 10 hours and changes every 2000 hours or 24 months. The data covers 7 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
T132 V (2010-2012)
  • Use: Normal
  • Capacity 30 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
T152 V (2010-2012)
  • Use: Normal
  • Capacity 30 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
T162 V (2010-2012)
  • Use: Normal
  • Capacity 30 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
T162e V (ECO) (2010-2012)
  • Use: Normal
  • Capacity 30 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
T172 V (2010-2012)
  • Use: Normal
  • Capacity 30 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
T182 V (2010-2012)
  • Use: Normal
  • Capacity 30 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months
T202 V (2010-2012)
  • Use: Normal
  • Capacity 30 liter
  • Check 10 hours
  • Change 2000 hours/ 24 months

Additional Notes

  • The Valtra (Valmet) T2 Versu cooling system capacity is 30 liters across all seven variants covered by these specifications, spanning the T132 V through the T202 V for model years 2010-2012. A uniform capacity across a range of power variants typically reflects a shared engine block architecture or cooling circuit design rather than individual engine displacement differences.
  • The 30-liter figure represents a service fill capacity, meaning the volume required to refill the cooling system during a standard coolant change rather than a full overhaul or block-drain procedure, which would generally yield a higher total system volume.
  • A coolant level check interval of 10 hours applies to all seven variants under normal use conditions. In agricultural machinery, a 10-hour check interval corresponds roughly to daily inspection during active field seasons, reflecting the high thermal and mechanical loads typical of tractor operation.
  • The coolant change interval is set at 2000 hours or 24 months, whichever comes first, under normal use conditions. The dual-trigger format means calendar time governs the interval even when annual operating hours fall short of the 2000-hour threshold, which is common in lower-utilization applications.
  • The T162e V (ECO) variant shares the same 30-liter cooling system capacity and identical check and change intervals as the standard T162 V, despite the ECO designation indicating a fuel-efficiency-oriented engine tune. The cooling circuit specifications are not differentiated between the two T162 variants in these data.
  • The consistency of the 2000-hour or 24-month change interval across the T132 V, T152 V, T162 V, T162e V, T172 V, T182 V, and T202 V suggests a single coolant specification governs the entire T2 Versu lineup for the 2010-2012 period, regardless of the power output differences implied by the model numbering.

Other Systems