Valtra (Valmet) T2 Direct

Brake fluid capacity & service interval

Valtra (Valmet) T2 Direct uses brake fluid with a capacity of 0,5 liter. Service intervals include checking at 500 hours and changing at 2000 hours or 24 months. The data covers 2 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
T132 D (2010-2012)
  • Use: Normal
  • Capacity 0,5 liter
  • Check 500 hours
  • Change 2000 hours/ 24 months
T152 D (2010-2012)
  • Use: Normal
  • Capacity 0,5 liter
  • Check 500 hours
  • Change 2000 hours/ 24 months

Additional Notes

  • The Valtra (Valmet) T2 Direct brake fluid capacity of 0.5 liter applies to the hydraulic brake system, which is a relatively small reservoir volume typical of enclosed hydraulic brake circuits on agricultural tractors.
  • Both the T132 D and T152 D share an identical 0.5 liter capacity, meaning no variation exists between the two engine configurations within the 2010-2012 production span.
  • The check interval is set at 500 hours under normal use conditions, which in tractor service terms represents a routine inspection point aligned with standard seasonal or annual operating cycles.
  • The change interval is defined as 2000 hours or 24 months, whichever comes first, reflecting a dual threshold that accounts for both high-utilization and lower-utilization operating patterns under normal conditions.
  • The 24-month calendar limit on the change interval means that fluid degradation over time is treated as a factor independent of accumulated operating hours, which is consistent with how hydraulic brake fluids absorb moisture and lose performance characteristics regardless of use frequency.

Other Systems