Holder M
Automatic transmission fluid capacity & service interval
Holder M automatic transmission fluid capacity ranges from 40 to 56 liters. Service intervals include checks at 125 hours and changes at 500 or 1500 hours. The data covers 2 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
|
|
|
|
Additional Notes
- The Holder M480 lists a capacity range of 40-56 liters for the transmission and hydrostatic/hydraulic system, which reflects a variable fill volume rather than a single fixed value, consistent with systems where fluid level depends on circuit configuration or component state during service.
- Under normal use conditions, the transmission and hydrostatic/hydraulic system carries a check interval of 125 hours, meaning fluid level or condition is verified at that interval well before a full drain and refill is due.
- The normal use change interval is set at 1500 hours, which is a long-cycle figure typical of hydraulic systems in compact utility or municipal equipment where fluid volume and operating conditions allow extended drain periods.
- A separate first-change-only interval of 500 hours applies to the same transmission and hydrostatic/hydraulic system, reflecting standard break-in practice where initial fluid carries metal particles and contaminants generated during early component wear-in.
- The 40-56 liter capacity range applies equally to both the normal and first-change-only service rows, indicating no difference in fill volume between a break-in drain and a standard scheduled change on the M480.