Holder L
Manual transmission fluid capacity & service interval
Holder L manual transmission fluid has a capacity range of 12,5 to 18,5 liters. Service intervals include checks at 125 hours and changes at 125 or 1500 hours. The data covers 4 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
|
|
|
|
|
|
|
|
Additional Notes
- The Holder L 560 front transmission carries a dry fill capacity of 18.5 liters, which represents the total fluid volume required when filling a completely drained or rebuilt unit from empty.
- Under normal use conditions, the L 560 front transmission service fill capacity is 12.5 liters, a figure meaningfully lower than the dry fill value and reflecting the residual fluid that remains in the unit during a routine drain.
- The L 560 front transmission specifies a fluid check interval of 125 hours under normal use conditions, paired with a full change interval of 1,500 hours.
- A first change only condition is listed for the L 560 front transmission, requiring a fluid change at 125 hours, which aligns with common break-in service practice where initial fluid contamination from component wear is addressed earlier than the standard interval.
- The L 780 front transmission shares the same 18.5-liter capacity figure as the L 560, though the L 780 specification does not distinguish between a dry fill and a service fill value.
- Under normal use conditions, the L 780 front transmission follows the same check and change intervals as the L 560, with a fluid check at 125 hours and a full change at 1,500 hours.
- The L 780 also carries a first change only entry, specifying a fluid change at 125 hours, consistent with the early-interval service approach seen on the L 560.