Goldoni Cluster series

Coolant capacity & service interval

Goldoni Cluster series uses coolant with a capacity of 7 liters. Service intervals include checks every 10 hours and changes every 24 months. The data covers 5 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Cluster 70 (ZA7300), VM D703-TI
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Cluster 70 RS (ZS7300I), VM D703-TI
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Cluster 70 RS REV (ZS730VI), VM D703-TI
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Cluster 70 RS REV Variant (ZS730VD), VM D703-TI
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months
Cluster 70 RS Variant (ZS7300D), VM D703-TI
  • Use: Normal
  • Capacity 7 liter
  • Check 10 hours
  • Change 24 months

Additional Notes

  • All five configurations in the Goldoni Cluster series covered here share an identical cooling system capacity of 7 liters, which represents the total fluid volume for the cooling circuit rather than a partial top-up quantity.
  • The VM D703-TI engine is the sole powerplant across every listed variant, meaning the uniform 7-liter capacity reflects a single engine family without cross-variant deviation.
  • A coolant level check interval of 10 hours applies under normal use conditions across all five configurations, indicating a relatively frequent inspection cycle consistent with agricultural equipment operating in demanding field environments.
  • The coolant change interval is set at 24 months under normal use conditions for every listed variant, meaning the service schedule is time-based rather than hour-based for the full drain-and-refill service.
  • The Cluster 70 RS REV (ZS730VI) and Cluster 70 RS REV Variant (ZS730VD) carry the same 7-liter capacity and 24-month change interval as the standard and non-reversible variants, indicating the reverser transmission configuration has no effect on cooling system volume or service timing.
  • The separation between a 10-hour check cycle and a 24-month change interval means the cooling system receives frequent monitoring well ahead of any scheduled fluid replacement, allowing condition assessment without committing to a full service.

Other Systems