Kymco Kiwi

Brake fluid capacity & service interval

Kymco Kiwi brake fluid capacity is between min and max. Service intervals include check 2000 km, change 24 months, and check 1000 km. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Kiwi 100 (2007- )
  • Use: Normal
  • Between min and max.
  • Check 2000 km
  • Change 24 months
Kiwi 100 (2007- )
  • Use: Initial service
  • Between min and max.
  • Check 1000 km
Kiwi 50 (2007- )
  • Use: Normal
  • Between min and max.
  • Check 2000 km
  • Change 24 months
Kiwi 50 (2007- )
  • Use: Initial service
  • Between min and max.
  • Check 1000 km

Additional Notes

  • The Kymco Kiwi brake fluid specification applies to a hydraulic brake system, meaning fluid level and condition directly affect braking performance through hydraulic pressure transmission.
  • Both the Kiwi 50 and Kiwi 100 share an identical fluid level target: the reservoir must read between the minimum and maximum marks rather than a fixed volume fill.
  • Under normal use conditions, the brake fluid level on both variants is scheduled for inspection every 2000 km.
  • A fluid change interval of 24 months applies to both the Kiwi 50 and Kiwi 100 under normal use conditions, reflecting the time-based degradation of brake fluid through moisture absorption regardless of mileage.
  • An initial service check is specified at 1000 km for both variants, which is half the recurring normal-use inspection interval, indicating a closer early inspection after the system has been broken in.
  • The initial service entry carries no fluid change interval, only a level check at 1000 km, while the 24-month change requirement is tied exclusively to the normal use condition rows.