Case Telescopic handlers, TX
Automatic transmission fluid capacity & service interval
Case Telescopic handlers, TX models utilize automatic transmission fluid with capacities ranging from 4 to 12.9 liters. The data covers 5 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
|
|
|
|
|
|
|
|
|
|
Additional Notes
- Across all five Case TX Telescopic Handler configurations covered — TX130-33, TX130-40, TX130-45, TX140-45, and TX170-45 — the powershift transmission carries a full-system capacity of 12.9 liters, a figure typical of a complete drain-and-refill or overhaul fill where the entire fluid circuit, including the torque converter and cooler lines, is evacuated.
- A secondary capacity of 4 liters is listed alongside the 12.9-liter figure for each configuration, a value consistent with a service fill where only the sump is drained and residual fluid remains in the converter and circuit passages.
- All five configurations share identical capacity values of 12.9 liters and 4 liters, despite spanning different model designations from the TX130-33 through to the TX170-45, indicating a common powershift transmission unit across the range.
- Each row is assigned a normal use condition, meaning the listed capacities apply to standard operating environments rather than severe-duty cycles that might otherwise alter service fill volumes or intervals.
- All configurations are paired with FPT (Fiat Powertrain Technologies) engines under Tier 3 emissions standards, with the TX130-33 using the F4GE9484F variant while the remaining four models use the F4GE9484J variant, though both engine variants share the same transmission fluid capacities.
- The specifications cover the 2007-2016 model years uniformly across all five configurations, with no variation in capacity values recorded across that span.