Toyota Sequoia, XK80 (USA / CAN)

Automatic transmission fluid capacity & service interval

Toyota Sequoia, XK80 (USA / CAN) automatic transmission fluid capacity is 11,7 liters. Service intervals include checks at 30000 miles or 36 months and changes at 60000 miles or 72 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Sequoia 3.4 AWD (2022- )
  • Use: Normal
  • Capacity 11,7 liter
  • Check 30000 miles/ 36 months
  • Code: 10/1
Sequoia 3.4 AWD (2022- )
  • Use: Severe
  • Capacity 11,7 liter
  • Check 30000 miles/ 36 months
  • Change 60000 miles/ 72 months
  • Code: 10/1
Sequoia 3.4 RWD (2022- )
  • Use: Normal
  • Capacity 11,7 liter
  • Check 30000 miles/ 36 months
  • Code: 10/1
Sequoia 3.4 RWD (2022- )
  • Use: Severe
  • Capacity 11,7 liter
  • Check 30000 miles/ 36 months
  • Change 60000 miles/ 72 months
  • Code: 10/1

Additional Notes

  • The Toyota Sequoia XK80 3.4 carries an automatic transmission fluid capacity of 11.7 liters, a figure that reflects a full service fill rather than a partial drain-and-fill, which typically recovers only a fraction of total system volume.
  • The 11.7-liter capacity is identical across both the AWD and RWD drivetrain configurations of the 3.4, indicating the transmission unit itself shares the same fluid volume regardless of which axles receive power.
  • Under normal use conditions, the service schedule for both AWD and RWD variants specifies a fluid check at 30,000 miles or 36 months, with no fluid change interval listed for normal use.
  • Under severe use conditions, the same 30,000-mile or 36-month check interval applies, and a fluid change is additionally specified at 60,000 miles or 72 months, doubling the check interval before a full replacement is required.
  • The 72-month severe-use change interval spans six years, which is a relatively extended period even for a severe-duty schedule, reflecting the sealed or low-maintenance design philosophy common in modern automatic transmissions.
  • The distinction between a check and a change is meaningful in service terms: a check involves inspecting fluid condition and level without necessarily replacing the fluid, while a change involves draining and refilling the system to the full 11.7-liter capacity.

Other Systems