Valtra (Valmet) F5 Series

Differential fluid capacity & service interval

Valtra (Valmet) F5 Series differential fluid capacity ranges from 2,7 to 3,8 liters. Service intervals include checks at 600 hours and changes at 1200 hours or 12 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • F 105 (2019- )
  • Front
  • Use: Normal
  • Capacity 3,2-3,8 liter (Standard)
  • Capacity 2,7-3,3 liter (narrow differential)
  • Check 600 hours
  • Change 1200 hours/ 12 months
  • Code: Dana
  • F 75 (2019- )
  • Front
  • Use: Normal
  • Capacity 3,2-3,8 liter (Standard)
  • Capacity 2,7-3,3 liter (narrow differential)
  • Check 600 hours
  • Change 1200 hours/ 12 months
  • Code: Dana
  • F 85 (2019- )
  • Front
  • Use: Normal
  • Capacity 3,2-3,8 liter (Standard)
  • Capacity 2,7-3,3 liter (narrow differential)
  • Check 600 hours
  • Change 1200 hours/ 12 months
  • Code: Dana
  • F 95 (2019- )
  • Front
  • Use: Normal
  • Capacity 3,2-3,8 liter (Standard)
  • Capacity 2,7-3,3 liter (narrow differential)
  • Check 600 hours
  • Change 1200 hours/ 12 months
  • Code: Dana

Additional Notes

  • All four Valtra (Valmet) F5 Series variants — the F 75, F 85, F 95, and F 105 — share identical front differential fluid specifications, meaning no capacity or interval differences exist across the model range for 2019 onward.
  • The standard front differential configuration carries a fluid capacity of 3.2–3.8 liters, while the narrow differential variant holds a notably smaller 2.7–3.3 liters, reflecting the reduced housing volume of the narrower axle design.
  • Both capacity figures are expressed as ranges rather than fixed values, which is typical for differential fills where the correct level is confirmed by a check plug rather than a precise measured pour.
  • The 0.5-liter difference between the upper bounds of the standard and narrow differential capacities — 3.8 liters versus 3.3 liters — represents a meaningful reduction in fluid volume that would affect heat dissipation and lubrication reserve in the narrower unit.
  • A fluid level check is specified at 600 hours under normal use conditions, placing the inspection interval at exactly half the full change interval, which allows for early detection of leaks or consumption before the scheduled drain.
  • The fluid change interval is set at 1,200 hours or 12 months under normal use conditions, whichever comes first, meaning calendar time can trigger a service requirement even when hour accumulation is low.

Other Systems