Same Frutteto CVT

Coolant capacity & service interval

Same Frutteto CVT uses coolant with a capacity of 12 liters. Service intervals include checks every 10 hours and changes every 2400 hours or 24 months. The data covers 10 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Frutteto CVT 100, Stage 5->ZKDHF90200TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 100, Stage 5->ZKDHW002W0TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 105, Stage 5->ZKDHG10200TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 105, Stage 5->ZKDLZ902W0TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 115, Stage 5->ZKDHG10200TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 115, Stage 5->ZKDHW402W0TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 90, Stage 5->ZKDHF80200TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 90, Stage 5->ZKDLZ102W0TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 95, Stage 5->ZKDHG00200TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months
Frutteto CVT 95, Stage 5->ZKDLZ502W0TS50001 (2020- )
  • Use: Normal
  • Capacity 12 liter
  • Check 10 hours
  • Change 2400 hours/ 24 months

Additional Notes

  • The Same Frutteto CVT cooling system capacity is 12 liters across all listed configurations, covering the 90, 95, 100, 105, and 115 power variants. A uniform capacity at this level reflects a full cooling system service fill, accounting for the radiator, engine block passages, and associated hoses rather than a partial top-up volume.
  • Each configuration carries two distinct serial number prefixes, one in the ZKDHF, ZKDHG, or ZKDHW series and one in the ZKDLZ series, yet both variants within each power rating share identical coolant capacity and service interval specifications.
  • The check interval is set at 10 hours of operation under normal use conditions, which is a very short interval by general agricultural machinery standards. A 10-hour check cycle is typical for critical fluid systems where early detection of leaks or concentration drift is prioritized during initial and ongoing operation.
  • The coolant change interval is defined by a dual threshold of 2400 hours or 24 months, whichever occurs first under normal use conditions. The time-based limit of 24 months reflects the chemical degradation of coolant additives over time, which can occur regardless of machine hours accumulated.
  • The 2400-hour operational threshold for coolant changes is consistent across all five power variants in the Stage 5 lineup, from the CVT 90 through the CVT 115, indicating no differentiation in service intervals based on engine output within the same emissions stage.
  • All listed configurations are designated Stage 5, referring to the EU Stage V emissions standard for non-road mobile machinery. Engines meeting Stage V requirements typically operate with more tightly managed thermal systems, which can influence both coolant capacity requirements and the frequency of condition checks.

Other Systems