Massey Ferguson 5600

Coolant capacity & service interval

Massey Ferguson 5600 uses coolant with a capacity range of 13,6 to 13,7 liters. Service intervals include checking every 10 hours and changing every 1500 hours or 24 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
MF 5608 Dyna-4 (2013-2018)
  • Use: Normal
  • Capacity 13,6 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
MF 5609 Dyna-4 (2013-2018)
  • Use: Normal
  • Capacity 13,6 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
MF 5610 Dyna-4 (2013-2018)
  • Use: Normal
  • Capacity 13,6 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
MF 5611 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 13,7 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
MF 5612 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 13,7 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
MF 5613 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 13,7 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months

Additional Notes

  • Across the Massey Ferguson 5600 series, cooling system capacities fall into two distinct values: 13.6 liters for the MF 5608, 5609, and 5610 in Dyna-4 configuration, and 13.7 liters for the MF 5611, 5612, and 5613 in both Dyna-4 and Dyna-6 configurations. The 0.1-liter difference aligns with the slightly larger engine displacement found in the upper models of the range.
  • The 13.6-liter and 13.7-liter figures represent full cooling system capacity, meaning the total volume of coolant held across the engine block, cylinder head, radiator, and associated hoses and reservoir. A full system fill of this size is typical of agricultural tractors where extended thermal management under sustained load is a design priority.
  • A 10-hour check interval applies uniformly across all six configurations. In agricultural equipment, a 10-hour interval corresponds roughly to daily checks during active field seasons, reflecting the high thermal and mechanical stress placed on cooling systems in continuous-duty tractor operation.
  • The coolant change interval is set at 1,500 hours or 24 months under normal use conditions, whichever comes first. The dual-trigger structure means that calendar time governs the change schedule even when annual operating hours fall well below 1,500, which is relevant for lower-utilization machines.
  • The MF 5611, 5612, and 5613 are each available in both Dyna-4 and Dyna-6 transmission variants, yet both share the same 13.7-liter cooling system capacity. The cooling system volume is therefore consistent regardless of transmission type within those models.
  • The 1,500-hour change interval is a relatively extended service interval for agricultural coolant, consistent with the use of long-life or extended-service coolant formulations. Such formulations typically rely on organic acid technology (OAT) or similar additive packages designed to maintain corrosion inhibition over longer service periods.

Other Systems