Massey Ferguson 5600

Automatic transmission fluid capacity & service interval

Massey Ferguson 5600 uses automatic transmission fluid with a capacity of 65-75 liters. Service intervals include checking every 10 hours and changing every 1500 hours or 24 months. The data covers 9 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
MF 5608 Dyna-4 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-4
MF 5609 Dyna-4 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-4
MF 5610 Dyna-4 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-4
MF 5611 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-4
MF 5611 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-6
MF 5612 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-4
MF 5612 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-6
MF 5613 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-4
MF 5613 Dyna-4/Dyna-6 (2013-2018)
  • Use: Normal
  • Capacity 65-75 liter
  • Check 10 hours
  • Change 1500 hours/ 24 months
  • Code: Dyna-6

Additional Notes

  • The transaxle capacity across all Massey Ferguson 5600 series models listed is specified as a range of 65-75 liters. A range rather than a fixed value reflects the integrated nature of agricultural transaxle systems, where a single housing combines the transmission, rear axle, and hydraulic reservoir, making the exact fill volume dependent on the specific configuration and fluid level at the time of service.
  • The Massey Ferguson 5608, 5609, and 5610 are available only with the Dyna-4 transmission, while the 5611, 5612, and 5613 are each available with either the Dyna-4 or the Dyna-6. Despite this difference in transmission option, the transaxle fluid capacity of 65-75 liters and the full service interval of 1500 hours or 24 months apply uniformly across both transmission types in the 5611-5613 range.
  • The change interval is expressed as 1500 hours or 24 months, whichever comes first. The dual-trigger format is standard practice for agricultural equipment, where seasonal or low-utilization machines may reach the calendar limit well before accumulating 1500 operating hours, making the time-based threshold the governing factor in those cases.
  • A fluid level check interval of 10 hours is specified for all listed models. In agricultural tractor service, a 10-hour check interval corresponds roughly to daily inspection during active field use, reflecting the importance of monitoring fluid levels in a large-capacity integrated transaxle system where leaks or consumption could go undetected over longer periods.
  • All entries across the 5608-5613 range carry a normal use condition designation. In equipment service classifications, normal use typically refers to operation within standard load, temperature, and duty-cycle parameters, as opposed to severe use conditions that would involve sustained heavy loads, extreme temperatures, or continuous high-hour operation.

Other Systems