Lindner Geotrac 4 (Alpin)

Manual transmission fluid capacity & service interval

Lindner Geotrac 4 (Alpin) manual transmission fluid capacity ranges from 32 to 52 liters. Service intervals include checks at 250 hours and changes at 500 or 1000 hours. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Geotrac 114ep DPF (2014- )
  • Use: Normal
  • Capacity 52 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: ZF Steyr
Geotrac 114ep DPF (2014- )
  • Use: Initial service
  • Capacity 52 liter
  • Check 250 hours
  • Change 500 hours
  • Code: ZF Steyr
Geotrac 134ep DPF (2014- )
  • Use: Normal
  • Capacity 52 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: ZF Steyr
Geotrac 134ep DPF (2014- )
  • Use: Initial service
  • Capacity 52 liter
  • Check 250 hours
  • Change 500 hours
  • Code: ZF Steyr
Geotrac 74ep DPF (2014- )
  • Use: Normal
  • Capacity 32 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: ZF Steyr
Geotrac 84ep DPF (2014- )
  • Use: Normal
  • Capacity 32 liter
  • Check 250 hours
  • Change 1000 hours
  • Code: ZF Steyr

Additional Notes

  • The Lindner Geotrac 4 (Alpin) transaxle manual transmission fluid capacity splits into two distinct groups across the lineup: the Geotrac 74ep DPF and Geotrac 84ep DPF both hold 32 liters, while the Geotrac 114ep DPF and Geotrac 134ep DPF each hold 52 liters.
  • A 52-liter transaxle fill is a notably large volume for a manual transmission system, reflecting the integrated nature of agricultural transaxle assemblies that combine the gearbox, differential, and hydraulic functions into a single shared fluid reservoir.
  • The Geotrac 114ep DPF and Geotrac 134ep DPF share an identical 52-liter capacity, a 250-hour check interval, and a 1000-hour normal service change interval, indicating the same transaxle unit is used across both variants.
  • Under normal use conditions, all six configurations in the Geotrac 4 (Alpin) lineup share a consistent 1000-hour fluid change interval, with fluid level checks scheduled every 250 hours regardless of engine size or capacity group.
  • An initial service change interval of 500 hours applies to the Geotrac 114ep DPF and Geotrac 134ep DPF transaxles, which is half the 1000-hour normal interval. Initial service intervals are typically specified to flush out metal particles and contaminants generated during the mechanical break-in period of a new transmission.
  • The 32-liter capacity of the Geotrac 74ep DPF and Geotrac 84ep DPF transaxles represents a 38-percent reduction compared to the 52-liter fill of the higher-powered variants, pointing to a physically smaller transaxle assembly in the lower-output models.

Other Systems