Landini Vision

Differential fluid capacity & service interval

Landini Vision differential fluid capacity ranges from 5,8 to 7,2 liters. Service intervals include checking at 100 hours and changing at 1000 hours or 12 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • Vision 100 (2004-2010)
  • Front
  • Use: Normal
  • Capacity 7,2 liter
  • Check 100 hours
  • Change 1000 hours/ 12 months
  • Vision 105 (2004-2010)
  • Front
  • Use: Normal
  • Capacity 7,2 liter
  • Check 100 hours
  • Change 1000 hours/ 12 months
  • Vision 80 (2004-2010)
  • Front
  • Use: Normal
  • Capacity 5,8 liter
  • Check 100 hours
  • Change 1000 hours/ 12 months
  • Vision 85 (2004-2010)
  • Front
  • Use: Normal
  • Capacity 5,8 liter
  • Check 100 hours
  • Change 1000 hours/ 12 months
  • Vision 90 (2004-2010)
  • Front
  • Use: Normal
  • Capacity 7,2 liter
  • Check 100 hours
  • Change 1000 hours/ 12 months
  • Vision 95 (2004-2010)
  • Front
  • Use: Normal
  • Capacity 7,2 liter
  • Check 100 hours
  • Change 1000 hours/ 12 months

Additional Notes

  • The Landini Vision front differential capacity splits into two distinct values across the model range: 5.8 liters for the Vision 80 and Vision 85, and 7.2 liters for the Vision 90, Vision 95, Vision 100, and Vision 105. In agricultural equipment, front differential capacity generally reflects the physical size of the axle housing and the torque demands placed on the front drive axle, with higher-horsepower models typically requiring larger fluid volumes to maintain adequate lubrication under load.
  • All six variants share an identical check interval of every 100 operating hours. On tractors used in field conditions, a 100-hour check interval allows for early detection of fluid contamination or level loss before a full drain-and-fill service becomes due.
  • The fluid change interval across all Vision models from 2004-2010 is set at 1,000 operating hours or 12 months, whichever comes first. The dual-trigger structure, combining a time-based limit with an hours-based limit, accounts for tractors that accumulate low annual hours, where fluid degradation from moisture ingress and oxidation can occur independently of mechanical wear.
  • The 5.8-liter front differential capacity of the Vision 80 and Vision 85 is notably smaller than the 7.2-liter figure shared by the four higher-output models. A difference of 1.4 liters between the two capacity groups suggests a physically different front axle assembly is fitted to the lower-horsepower variants rather than a simple recalibration of the same unit.
  • All specifications are listed under normal use conditions. In tractor service documentation, normal use typically describes standard agricultural field operation, as opposed to severe conditions such as continuous heavy draft work, extreme temperatures, or frequent water crossings, which may warrant shorter intervals.
  • The Vision 90, Vision 95, Vision 100, and Vision 105 all share the 7.2-liter front differential capacity despite spanning a range of power outputs. Shared capacity across multiple power ratings within the same model family commonly indicates a common front axle platform scaled to handle the upper end of the range.

Other Systems