Holder F

Manual transmission fluid capacity & service interval

Holder F manual transmission fluid capacity ranges from 10,5 to 14,5 liters. Service intervals include checks at 125 hours and changes at 125 or 1500 hours. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • F 780 (2010- )
  • Front
  • Use: Normal
  • Capacity 10,75 liter
  • Check 125 hours
  • Change 1500 hours
  • F 780 (2010- )
  • Front
  • Use: First change only
  • Capacity 10,75 liter
  • Change 125 hours
  • F 560 (2006- )
  • Front
  • Use: Normal
  • Capacity 14,5 liter (Dry fill)
  • Capacity 10,5 liter (Service fill)
  • Check 125 hours
  • Change 1500 hours
  • F 560 (2006- )
  • Front
  • Use: First change only
  • Capacity 14,5 liter (Dry fill)
  • Capacity 10,5 liter (Service fill)
  • Change 125 hours

Additional Notes

  • The Holder F 560 front transmission carries a dry fill capacity of 14.5 liters, which represents the total fluid volume required when filling a completely drained or rebuilt unit, as opposed to a routine service top-up.
  • The F 560 front transmission service fill capacity is 10.5 liters, reflecting the smaller volume needed during a standard fluid change where residual fluid remains in the system after draining.
  • The F 780 front transmission lists a single capacity figure of 10.75 liters without a separate dry fill value, meaning no distinction between overhaul and service fill volumes is specified for that configuration.
  • Under normal use conditions, the F 560 front transmission fluid is subject to a check interval of 125 hours and a change interval of 1,500 hours.
  • The F 780 front transmission follows the same interval structure under normal use, with a fluid check at 125 hours and a full change at 1,500 hours.
  • Both the F 560 and F 780 front transmissions carry a first-change-only interval of 125 hours, meaning the initial fluid change after a new or rebuilt unit enters service occurs significantly earlier than subsequent routine changes.
  • The first-change-only interval of 125 hours aligns with the standard check interval, indicating that the first service event serves as both an inspection point and an early fluid replacement for a freshly filled transmission.

Other Systems