Deutz-Fahr Series 5G TB

Brake fluid capacity & service interval

Deutz-Fahr Series 5G TB requires 1 liter of brake fluid. The service interval for checking the fluid is 50 hours. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
5080 G TB, Stage 3B->ZKDDL00200TD50001 (2017- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5080 G TB, Stage 3B->ZKDDL30200TD50001 (2017- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5105 G TB, Stage 3B->ZKDDS50200TD50001 (2017- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5105 G TB, Stage 3B->ZKDDT30200TD50001 (2017- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5115 G TB, Stage 3B->ZKDDS60200TD50001 (2017- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5115 G TB, Stage 3B->ZKDDT40200TD50001 (2017- )
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours

Additional Notes

  • The Deutz-Fahr Series 5G TB hydraulic brake system holds a capacity of 1 liter across all six listed configurations, covering the 5080 G TB, 5105 G TB, and 5115 G TB variants. A 1-liter figure for a hydraulic brake system reservoir is consistent with the relatively compact fluid volume typical of tractor brake circuits, as opposed to the much larger capacities associated with transmission or hydraulic lift systems.
  • All six configurations share an identical 50-hour check interval under normal use conditions. In agricultural equipment, a 50-hour interval reflects a relatively frequent inspection cycle, which is common for brake fluid checks given the safety-critical nature of braking systems and the potential for fluid contamination or level drop during heavy field use.
  • The serial number prefixes distinguish the two 5080 G TB entries from each other: one begins at ZKDDL00200TD50001 and the other at ZKDDL30200TD50001, both from 2017 onward. Despite the different serial ranges, both share the same 1-liter capacity and 50-hour check interval, indicating no variation in brake system specification between those two production sequences.
  • The 5105 G TB appears in two separate serial number lines as well, with prefixes ZKDDS50200TD50001 and ZKDDT30200TD50001. As with the 5080 G TB pairings, both entries carry identical brake fluid specifications, suggesting the serial number differentiation reflects production or regional variants rather than any mechanical difference in the brake circuit.
  • The 5115 G TB, the highest-numbered model in the listed range, follows the same pattern with two serial number variants starting at ZKDDS60200TD50001 and ZKDDT40200TD50001. The brake fluid capacity and check interval remain unchanged at 1 liter and 50 hours, consistent with all other configurations in the series.
  • The check interval specified is exactly that — a check, not a full fluid replacement. In hydraulic brake systems, periodic checks typically involve inspecting fluid level and condition rather than a complete drain and refill, which would normally occur at a longer, separately defined service interval.

Other Systems