Deutz-Fahr Series 5 D TTV

Differential fluid capacity & service interval

Deutz-Fahr Series 5 D TTV differential fluid capacity is 6 liters. Service intervals include checks at 300 hours and changes at 1200 hours or 12 months. The data covers 8 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • 5090 D TTV, Stage 3B->ZKDET60200TD50001 (2021- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • 5090.4 D TTV, Stage 3B->ZKDEU40200TD50001 (2021- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • 5095 D TTV, Stage 5->ZKDHU70200TD50001 (2021- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • 5100 D TTV, Stage 3B->ZKDEU00200TD50001 (2021- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • 5100.4 D TTV, Stage 3B->ZKDEU80200TD50001 (2021- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • 5105 D TTV, Stage 5->ZKDHU80200TD50001 (2021- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • 5110.4 D TTV, Stage 3B->ZKDEV20200TD50001 (2021- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months
  • 5115 D TTV, Stage 5->ZKDHU90200TD50001 (2021- )
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 300 hours
  • Change 1200 hours/ 12 months

Additional Notes

  • The Deutz-Fahr Series 5 D TTV front differential fluid capacity is 6 liters across all listed configurations, covering the 5090 D TTV through the 5115 D TTV. A consistent capacity across a range of models typically reflects a shared axle assembly design rather than model-specific hardware differences.
  • The Series 5 D TTV lineup spans two distinct emissions certification tiers: Stage 3B and Stage 5. The 5095 D TTV, 5105 D TTV, and 5115 D TTV carry Stage 5 certification, while the 5090 D TTV, 5090.4 D TTV, 5100 D TTV, 5100.4 D TTV, and 5110.4 D TTV are Stage 3B certified. Despite this difference in engine emissions standards, the front differential fluid capacity and service intervals are identical across both tiers.
  • The ".4" suffix appearing on the 5090.4 D TTV, 5100.4 D TTV, and 5110.4 D TTV designations indicates a four-wheel drive variant distinct from the standard configuration. All three share the same 6-liter front differential capacity and the same check and change intervals as the non-.4 models.
  • The fluid check interval for the front differential is set at 300 hours under normal use conditions. In agricultural machinery, a 300-hour check interval is a relatively frequent inspection point, reflecting the demanding operating environments typical of tractor use.
  • The fluid change interval is specified at 1200 hours or 12 months, whichever comes first, under normal use conditions. The dual-trigger structure means calendar time can mandate a change even when the hourly threshold has not been reached, which is relevant for machines operated at lower annual hours.
  • The ratio between the check interval and the change interval is 1:4, meaning the fluid is inspected four times for every one full drain-and-fill service cycle. This structure allows for early detection of contamination or level loss without requiring a full fluid change at each inspection.
  • Each configuration is identified by a unique serial number prefix beginning with "ZKDE" or "ZKDH," followed by model-specific alphanumeric codes. These serial number thresholds, all starting from 2021, define the exact production point from which the listed specifications apply.

Other Systems