Deutz-Fahr Series 5 C

Differential fluid capacity & service interval

Deutz-Fahr Series 5 C uses differential fluid with a capacity of 6 liters. Service intervals include checking at 250 hours and changing at 1000 hours or 12 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • 5090 C, -> ZKDY360200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 5100 C, -> ZKDY400200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 5100 C, -> ZKDY480200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 5110 C, -> ZKDY440200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 5110 C, -> ZKDY520200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months
  • 5120 C, -> ZKDY560200TD10001 (2014-2018)
  • Front
  • Use: Normal
  • Capacity 6 liter
  • Check 250 hours
  • Change 1000 hours/ 12 months

Additional Notes

  • All six configurations of the Deutz-Fahr Series 5 C covered here share an identical front differential fluid capacity of 6 liters, indicating a consistent front axle housing design across the 5090 C, 5100 C, 5110 C, and 5120 C variants produced from 2014-2018.
  • Each configuration is identified by a unique serial number prefix (e.g., ZKDY360200TD10001, ZKDY400200TD10001), which reflects production-line differentiation even where mechanical specifications are otherwise uniform.
  • The 6-liter front differential capacity is a service fill figure, representing the fluid volume required during a standard drain-and-refill procedure rather than a full overhaul or housing replacement, which would typically require additional measurement to account for residual fluid.
  • The change interval is specified as 1000 hours or 12 months under normal use conditions, whichever comes first. The dual-trigger format is common in agricultural equipment servicing, where seasonal or calendar-based maintenance aligns with off-season periods regardless of accumulated operating hours.
  • A separate check interval of 250 hours is specified alongside the change interval. At this shorter interval, fluid level and condition are assessed without a full drain, allowing early detection of contamination or leakage between full service events.
  • The 5100 C appears under two distinct serial number prefixes — ZKDY400200TD10001 and ZKDY480200TD10001 — both covering the 2014-2018 period. Despite the differing serial ranges, both share the same 6-liter capacity and service intervals for the front differential.
  • Similarly, the 5110 C is listed under two serial number prefixes — ZKDY440200TD10001 and ZKDY520200TD10001 — again with no variation in front differential specifications between the two production sequences.

Other Systems