Deutz-Fahr Series 5 C

Brake fluid capacity & service interval

Deutz-Fahr Series 5 C uses brake fluid with a capacity of 1 liter. Service intervals require a check every 50 hours. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
5090 C, -> ZKDY360200TD10001 (2014-2018)
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5100 C, -> ZKDY400200TD10001 (2014-2018)
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5100 C, -> ZKDY480200TD10001 (2014-2018)
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5110 C, -> ZKDY440200TD10001 (2014-2018)
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5110 C, -> ZKDY520200TD10001 (2014-2018)
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours
5120 C, -> ZKDY560200TD10001 (2014-2018)
  • Use: Normal
  • Capacity 1 liter
  • Check 50 hours

Additional Notes

  • The Deutz-Fahr Series 5 C hydraulic brake system holds a uniform 1-liter capacity across all six configurations spanning the 5090 C, 5100 C, 5110 C, and 5120 C variants. In hydraulic brake systems, this figure represents the total fluid volume held within the reservoir and circuit, not a drain-and-fill service quantity.
  • Each configuration carries a serial number threshold in its designation, such as ZKDY360200TD10001 for the 5090 C, indicating that the listed specifications apply to units produced up to and including those serial numbers within the 2014-2018 model year span.
  • The 50-hour check interval applies uniformly under normal use conditions across all six rows. In agricultural machinery, a 50-hour interval is a relatively frequent service point, reflecting the demanding operating environments typical of tractor use where brake fluid condition and reservoir level require regular monitoring.
  • The 5100 C appears under two distinct serial number thresholds, ZKDY400200TD10001 and ZKDY480200TD10001, both sharing identical capacity and interval specifications. The presence of two separate serial ranges for the same model designation suggests production batches or regional variants that were tracked separately despite carrying the same brake system parameters.
  • Similarly, the 5110 C is listed under two serial number thresholds, ZKDY440200TD10001 and ZKDY520200TD10001, again with no variation in the 1-liter capacity or 50-hour check interval between them.
  • The service action specified is a check rather than a fluid replacement, meaning the 50-hour interval is an inspection point for fluid level and condition rather than a scheduled drain-and-refill procedure.

Other Systems