Iveco EuroCargo Tector CNG

Manual transmission fluid capacity & service interval

Iveco EuroCargo Tector CNG manual transmission fluid capacity is 9,5 liters. Service intervals are 360000 km/36 months and 240000 km/24 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
EuroCargo Tector CNG ML 120E(L)21 (2016- )
  • Use: Normal (preferred)
  • Capacity 9,5 liter
  • Change 360000 km/ 36 months
  • Code: ZF 9S-75 9/1
EuroCargo Tector CNG ML 120E(L)21 (2016- )
  • Use: Normal (alternative)
  • Capacity 9,5 liter
  • Change 240000 km/ 24 months
  • Code: ZF 9S-75 9/1
EuroCargo Tector CNG ML 160E21 (2016- )
  • Use: Normal (preferred)
  • Capacity 9,5 liter
  • Change 360000 km/ 36 months
  • Code: ZF 9S-75 9/1
EuroCargo Tector CNG ML 160E21 (2016- )
  • Use: Normal (alternative)
  • Capacity 9,5 liter
  • Change 240000 km/ 24 months
  • Code: ZF 9S-75 9/1

Additional Notes

  • Across all listed configurations of the Iveco EuroCargo Tector CNG, the manual transmission fluid capacity is 9.5 liters, a figure consistent with a service fill rather than a full overhaul volume, as overhaul capacities typically account for additional fluid retained in components during disassembly.
  • The ML 120E(L)21 and ML 160E21 variants both share the same 9.5-liter capacity, indicating no variation in transmission fluid volume between the two configurations despite differences in their power ratings.
  • Under normal use with the preferred fluid, the change interval for both the ML 120E(L)21 and ML 160E21 reaches 360,000 km or 36 months, whichever comes first, reflecting an extended-drain specification tied to the use of a higher-grade lubricant.
  • When the alternative fluid is used under normal conditions, the change interval shortens to 240,000 km or 24 months for both configurations, a reduction of 120,000 km and 12 months compared to the preferred fluid interval.
  • The 2016 starting year applies equally to both the ML 120E(L)21 and ML 160E21 in the specifications, meaning both configurations share the same introduction point for the listed fluid and interval data.

Other Systems