Iveco EuroCargo Tector (4x4)

Coolant capacity & service interval

Iveco EuroCargo Tector (4x4) coolant capacity ranges from 11 to 18 liters. Service intervals include a 12 month check and a 36 month change. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
EuroCargo Tector ML 110 E22W (4x4) Euro 6 (2015- )
  • Use: Normal
  • Capacity 11 liter
  • Capacity 17-18 liter (+ Allison automatic gearbox)
  • Check 12 months
  • Change 36 months
EuroCargo Tector ML 150 E25W (4x4) Euro 6 (2015- )
  • Use: Normal
  • Capacity 12 liter
  • Capacity 17-18 liter (+ Allison automatic gearbox)
  • Check 12 months
  • Change 36 months
EuroCargo Tector ML 150 E28W (4x4) Euro 6 (2015- )
  • Use: Normal
  • Capacity 12 liter
  • Capacity 17-18 liter (+ Allison automatic gearbox)
  • Check 12 months
  • Change 36 months

Additional Notes

  • The Iveco EuroCargo Tector (4x4) ML 110 E22W Euro 6 carries a base cooling system capacity of 11 liters, while the ML 150 E25W and ML 150 E28W Euro 6 variants each carry 12 liters, reflecting a modest but consistent difference between the 110 and 150 series configurations.
  • When paired with an Allison automatic gearbox, all three variants share an expanded cooling system capacity of 17-18 liters, a notably higher figure that accounts for the additional thermal load and fluid volume introduced by the transmission cooler circuit.
  • The 17-18 liter range listed for the Allison automatic gearbox configuration represents a variable fill rather than a fixed value, which is typical when transmission cooler integration affects total system volume depending on line routing and cooler size.
  • A coolant check interval of 12 months applies to all three variants under normal use conditions, meaning the system level and concentration are to be inspected on an annual basis regardless of mileage.
  • The coolant change interval across all three variants is set at 36 months under normal use, placing the full drain-and-refill service on a three-year cycle rather than a mileage-based one.
  • The separation between a 12-month check and a 36-month change interval means the cooling system is inspected three times before a full fluid replacement is due, allowing condition monitoring without premature fluid changes.

Other Systems