Kymco Dink

Coolant capacity & service interval

Kymco Dink coolant capacity ranges from 0,9 to 1,2 liters. Service intervals include checks at 3000 km, changes at 10000 km, and changes at 12 or 24 months. The data covers 5 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Dink 180i (2012- )
  • Use: Normal
  • Capacity 0,9 liter
  • Check 3000 km
  • Change 10000 km/ 12 months
Dink 125 (2007- )
  • Use: Normal
  • Capacity 1,2 liter
  • Check 3000 km
  • Change 10000 km/ 12 months
Dink 200i (2007- )
  • Use: Normal
  • Between min and max.
  • Change 24 months
Dink 50 (water) (2007- )
  • Use: Normal
  • Between min and max.
  • Change 10000 km
Dink 150 (1999- )
  • Use: Normal
  • Capacity 1,17 liter
  • Check 3000 km
  • Change 10000 km/ 12 months

Additional Notes

  • The Kymco Dink 125 (2007- ) cooling system holds 1.2 liters, the largest capacity among the Dink variants listed, while the Dink 150 (1999- ) sits just below at 1.17 liters and the Dink 180i (2012- ) drops to 0.9 liters despite its larger displacement relative to the 125.
  • The 0.9-liter coolant capacity of the Dink 180i represents the smallest figure across all Dink configurations with a stated volume, reflecting how engine architecture and cooling circuit design can result in smaller systems in higher-displacement variants.
  • The Dink 125, Dink 150, and Dink 180i all share the same check interval of every 3,000 km, paired with a change interval of 10,000 km or 12 months under normal use conditions, whichever comes first.
  • The Dink 200i (2007- ) departs from the kilometer-based change interval used by other Dink variants, specifying a coolant change at 24 months under normal use with no stated kilometer threshold, making time the sole trigger for service.
  • The Dink 50 (water) (2007- ) specifies a coolant change at 10,000 km under normal use but carries no time-based interval alongside it, unlike the 12-month pairing seen on the 125, 150, and 180i.
  • Neither the Dink 200i nor the Dink 50 (water) list a specific coolant volume, instead referencing a level between the minimum and maximum marks on the reservoir. This approach ties service to a visual inspection rather than a measured fill quantity.
  • The 3,000 km check interval on the Dink 125, Dink 150, and Dink 180i is separate from the change interval, meaning the cooling system level is inspected more than three times before a full coolant change is due at 10,000 km.

Other Systems