Kymco Dink
Brake fluid capacity & service interval
Kymco Dink uses brake fluid with a capacity range between min and max. Service intervals include checks at 1000 km, 1500 km, and 2000 km, with changes at 10000 km/12 months or 24 months. The data covers 6 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| Dink 125 (2007- ) |
|
| Dink 125 (2007- ) |
|
| Dink 200i (2007- ) |
|
| Dink 50 (air) (2007- ) |
|
| Dink 50 (water) (2007- ) |
|
| Dink 50 4T (2007- ) |
|
Additional Notes
- Across all Kymco Dink variants listed, the brake fluid level specification is expressed as a range rather than a fixed volume, requiring the fluid to sit between the minimum and maximum marks on the reservoir. This approach is standard for hydraulic brake systems, where the reservoir level naturally drops slightly as brake pads wear.
- The Dink 125 (2007- ) carries two separate service entries for its hydraulic brake system. Under normal use conditions, checks are scheduled every 2000 km with a full fluid change due at 10,000 km or 12 months, whichever comes first. The 12-month interval reflects the hygroscopic nature of brake fluid, which absorbs moisture over time regardless of mileage.
- The initial service entry for the Dink 125 (2007- ) specifies a brake fluid check at 1000 km, which is half the interval applied under normal ongoing use. An early inspection at this stage allows for verification of system integrity and fluid condition after the first period of operation.
- The Dink 200i (2007- ) specifies a brake fluid change interval of 24 months under normal use, with no distance-based check interval listed. A time-only interval of 24 months is longer than the 12-month change cycle on the Dink 125, representing a notable difference between the two engine displacement variants.
- Both the Dink 50 (air) and Dink 50 (water) variants share identical brake fluid specifications under normal use conditions, with a check interval of 1500 km and a change interval of 24 months. The shared specification applies despite the difference in cooling system design between the two 50cc variants.
- The Dink 50 4T (2007- ) lists only a 24-month change interval for its hydraulic brake system under normal use, with no distance-based check interval specified. In contrast, the air-cooled and water-cooled Dink 50 variants both include a 1500 km check interval alongside the same 24-month change schedule.