Peugeot Partner, B9
Differential fluid capacity & service interval
Peugeot Partner B9 differential fluid capacity is 1,1 liters. Service intervals include 20000 km/24 months and 15000 km/12 months. The data covers 8 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Additional Notes
- All rear differential entries across the Peugeot Partner B9 DANGEL 4x4 range share a uniform fluid capacity of 1.1 liters. A capacity at this level is typical of a compact rear differential unit, reflecting a relatively small housing volume rather than a larger axle assembly found in heavier commercial or off-road vehicles.
- The DANGEL 4x4 designation identifies a four-wheel-drive conversion applied to the Partner B9 platform by the specialist manufacturer Dangel, which explains the presence of a rear differential where the standard front-wheel-drive Partner would have none.
- Under normal use conditions, the rear differential fluid change interval is set at 20,000 km or 24 months across all three engine variants covered: the 1.6 HDi 90 DPF, the 1.6 HDi 115, and the 1.6 BlueHDi 100.
- Under severe use conditions, the rear differential fluid change interval shortens to 15,000 km or 12 months for all listed configurations. Severe use typically encompasses frequent low-speed operation, heavy loads, off-road driving, or repeated short trips, all of which accelerate fluid degradation.
- The time-based component of the severe-use interval is half that of the normal-use interval (12 months versus 24 months), while the distance-based component is reduced by 25 percent (15,000 km versus 20,000 km). The proportionally larger reduction in the time limit reflects how calendar aging and moisture contamination affect differential fluid independently of mileage accumulation.
- The 1.6 HDi 90 DPF variant covers two separate production periods in the specifications: 2008-2011 and 2012-2015. Both periods carry identical capacity and interval figures, indicating no change to the rear differential specification between those production phases despite the engine code remaining the same across both.
- The 1.6 HDi 115 (engine code 9HD) covers the 2012-2015 period, while the 1.6 BlueHDi 100 (engine code BHY) covers 2014-2018. The BlueHDi designation refers to Peugeot's later-generation diesel technology incorporating a selective catalytic reduction system, yet the rear differential specification remains unchanged relative to the older HDi variants.