Iveco Leoncino

Brake fluid capacity & service interval

Iveco Leoncino uses brake fluid with a capacity of 2,6 liters. Service intervals include checks at 15000 km, 300 hours, or 12 months, and fluid changes every 24 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Leoncino DL50Y12 (2010-2013)
  • Use: Normal
  • Capacity 2,6 liter
  • Check 15000 km/ 300 hours/ 12 months
  • Change 24 months
Leoncino DL50Y13 (2010-2013)
  • Use: Normal
  • Capacity 2,6 liter
  • Check 15000 km/ 300 hours/ 12 months
  • Change 24 months
Leoncino DL60Y12 (2010-2013)
  • Use: Normal
  • Capacity 2,6 liter
  • Check 15000 km/ 300 hours/ 12 months
  • Change 24 months
Leoncino DL60Y13 (2010-2013)
  • Use: Normal
  • Capacity 2,6 liter
  • Check 15000 km/ 300 hours/ 12 months
  • Change 24 months
Leoncino DN35Y12 (2010-2013)
  • Use: Normal
  • Capacity 2,6 liter
  • Check 15000 km/ 300 hours/ 12 months
  • Change 24 months
Leoncino DN35Y13 (2010-2013)
  • Use: Normal
  • Capacity 2,6 liter
  • Check 15000 km/ 300 hours/ 12 months
  • Change 24 months

Additional Notes

  • All six Leoncino configurations covered in the 2010-2013 range share an identical hydraulic brake system fluid capacity of 2.6 liters. A capacity at this level is consistent with a full hydraulic circuit fill, accounting for the master cylinder reservoir, brake lines, and actuating cylinders across all axles.
  • The DL50Y12, DL50Y13, DL60Y12, DL60Y13, DN35Y12, and DN35Y13 variants all carry the same 2.6-liter figure, indicating no variation in brake system volume across the DL50, DL60, and DN35 model designations within this generation.
  • The check interval is defined by three separate thresholds: 15,000 km, 300 hours, or 12 months, whichever comes first. The inclusion of an hour-based threshold alongside distance and calendar intervals reflects the operational profile of light commercial vehicles, which may accumulate engine hours through low-speed or stationary work without covering significant road distance.
  • The change interval is set at 24 months across all six configurations, independent of distance or hours. Brake fluid absorbs moisture over time through a process called hygroscopic absorption, which lowers the fluid's boiling point. A time-based change interval addresses this degradation mechanism regardless of how much the vehicle has been driven.
  • The separation between the check interval (12 months or 15,000 km or 300 hours) and the change interval (24 months) means the fluid is inspected at least once between each full replacement. A check at the shorter interval allows for early detection of contamination or level loss without committing to a full fluid exchange at every service.
  • The specifications apply under normal use conditions for all listed variants. The uniform application of normal-use intervals across the DL50, DL60, and DN35 series suggests the brake system service schedule was standardized across the Iveco Leoncino range for this generation rather than differentiated by payload class or axle configuration.

Other Systems