Welte Skidders

Brake fluid capacity & service interval

Welte Skidders use brake fluid with a capacity of 0,5 liter. The service interval for fluid changes is 24 months. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
W110, Deutz TCD 2013 L04 2V (2010-2014)
  • Use: Normal
  • Capacity 0,5 liter
  • Change 24 months
W130/K/M/T (113 kW), Deutz TCD 2013 L04 2V (2010-2014)
  • Use: Normal
  • Capacity 0,5 liter
  • Change 24 months
W130/K/M/T (129 kW), Deutz TCD 2013 L04 2V (2010-2014)
  • Use: Normal
  • Capacity 0,5 liter
  • Change 24 months
W180, Deutz TCD 2013 L04 2V (2010-2014)
  • Use: Normal
  • Capacity 0,5 liter
  • Change 24 months
W210, Deutz TCD 2013 L04 2V (2010-2014)
  • Use: Normal
  • Capacity 0,5 liter
  • Change 24 months
W230, Deutz TCD 2013 L04 2V (2010-2014)
  • Use: Normal
  • Capacity 0,5 liter
  • Change 24 months

Additional Notes

  • All six Welte Skidders configurations covered in the 2010-2014 range share a uniform hydraulic brake system capacity of 0.5 liter, a relatively small volume consistent with a dedicated brake fluid reservoir rather than a combined hydraulic circuit fill.
  • The 24-month change interval applies under normal use conditions across every listed configuration, meaning the replacement schedule is time-based rather than tied to operating hours or mileage.
  • A time-based brake fluid interval of 24 months reflects the hygroscopic nature of brake fluid, which absorbs moisture from the atmosphere over time and lowers its boiling point regardless of how much the machine has been operated.
  • The W130 variant appears in two distinct power outputs within the same 2010-2014 model year range and the same Deutz TCD 2013 L04 2V engine family: one rated at 113 kW and another at 129 kW. Despite the power difference, both share the identical 0.5-liter brake fluid capacity and 24-month service interval.
  • The W130 designation also spans multiple body or configuration suffixes (K, M, T), yet the brake system specifications remain unchanged across all of them, indicating a common hydraulic brake circuit design within the W130 family.
  • The capacity figure of 0.5 liter is consistent across the full model range from the W110 through the W230, suggesting a standardized brake fluid reservoir was used across different machine sizes within the Welte Skidders lineup for the 2010-2014 period.

Other Systems