Fenwick Forklift trucks, diesel (022 series)

Automatic transmission fluid capacity & service interval

Fenwick Forklift trucks, diesel (022 series) require automatic transmission fluid with a capacity of 21 liters. Service intervals include a check at 10 hours and a change at 1000 hours. The data covers 6 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • H180, Scania DS9 62A (1995- )
  • Powershift
  • Use: Normal
  • Capacity 21 liter
  • Check 10 hours
  • Change 1000 hours
  • Code: 3/3
  • H200, Scania DS9 62A (1995- )
  • Powershift
  • Use: Normal
  • Capacity 21 liter
  • Check 10 hours
  • Change 1000 hours
  • Code: 3/3
  • H220, Scania DS9 62A (1995- )
  • Powershift
  • Use: Normal
  • Capacity 21 liter
  • Check 10 hours
  • Change 1000 hours
  • Code: 3/3
  • H236, Scania DS9 62A (1995- )
  • Powershift
  • Use: Normal
  • Capacity 21 liter
  • Check 10 hours
  • Change 1000 hours
  • Code: 3/3
  • H250, Scania DS9 62A (1995- )
  • Powershift
  • Use: Normal
  • Capacity 21 liter
  • Check 10 hours
  • Change 1000 hours
  • Code: 3/3
  • H280, Scania DS9 62A (1995- )
  • Powershift
  • Use: Normal
  • Capacity 21 liter
  • Check 10 hours
  • Change 1000 hours
  • Code: 3/3

Additional Notes

  • All six configurations in the Fenwick Forklift trucks, diesel (022 series) covered here pair the Scania DS9 62A engine with a powershift transmission, and every one of them carries an identical automatic transmission fluid capacity of 21 liters.
  • A 21-liter capacity is notably large relative to passenger vehicle automatic transmissions, which typically hold between 7 and 12 liters. In heavy industrial powershift applications, the greater volume supports the higher thermal and mechanical loads generated during continuous load-cycle operation.
  • The H180, H200, H220, H236, H250, and H280 variants all share the same 10-hour fluid check interval. In forklift service, hours-based intervals replace distance-based ones because machine utilization is measured in engine or operational hours rather than kilometers or miles.
  • A 10-hour check interval corresponds roughly to a daily inspection schedule in a single-shift operation, reflecting the importance of monitoring fluid level and condition frequently in powershift transmissions subject to repeated directional changes and load engagement.
  • The fluid change interval across all six configurations is set at 1,000 hours under normal use conditions. Normal use in industrial equipment contexts generally refers to operation within the manufacturer's rated load, speed, and temperature parameters, as opposed to severe conditions involving sustained overloading or extreme ambient temperatures.
  • The uniform 1,000-hour change interval across the H180 through H280 range indicates that despite differences in rated capacity between models, the shared Scania DS9 62A engine and powershift transmission assembly carries consistent fluid service requirements throughout the lineup starting from 1995.

Other Systems