Ausa Forklift trucks

Brake fluid capacity & service interval

Ausa Forklift trucks require 0,25 liter of Brake fluid. The service interval for fluid replacement is 1000 hours. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
C 130 H (4x2), Isuzu 3LB1 (2002- )
  • Use: Normal
  • Capacity 0,25 liter
  • Change 1000 hours
C 130 H (4x4), Isuzu 3LB1 (2002- )
  • Use: Normal
  • Capacity 0,25 liter
  • Change 1000 hours
C 150 H (4x2), Isuzu 3LD1 (2002- )
  • Use: Normal
  • Capacity 0,25 liter
  • Change 1000 hours
C 150 H (4x4), Isuzu 3LD1 (2002- )
  • Use: Normal
  • Capacity 0,25 liter
  • Change 1000 hours

Additional Notes

  • The Ausa Forklift trucks brake fluid capacity is listed at 0.25 liter across the C 130 H and C 150 H configurations, which is a small volume consistent with a compact hydraulic brake circuit rather than a large reservoir system.
  • The 0.25 liter figure applies uniformly to both the 4x2 and 4x4 drivetrain variants of the C 130 H, indicating the hydraulic brake system volume does not change with the addition of four-wheel drive on that model.
  • The same 0.25 liter capacity carries over to the C 150 H in both 4x2 and 4x4 configurations, meaning the step up to the larger Isuzu 3LD1 engine from the 3LB1 has no effect on the brake fluid reservoir size.
  • All four configurations share a 1000-hour change interval, which is a time-in-operation measure rather than a calendar or mileage-based one, reflecting the industrial and off-road working context of forklift trucks.
  • The 1000-hour interval is specified under normal use conditions, meaning the interval is tied to standard operating demands rather than severe or exceptional duty cycles.
  • The note designating a hydraulic brake system applies to all four rows, which distinguishes the brake circuit as hydraulically actuated, a detail relevant to fluid selection and system maintenance procedures.

Other Systems