Amkodor Wheeled loaders
Brake fluid capacity & service interval
Amkodor wheeled loaders require brake fluid with a capacity of 0,5 liter. The service interval for fluid replacement is 2000 hours. The data covers 5 configurations.
The configuration chart below lists fill volumes and service intervals for each engine and trim variant.
| Type | Specifications |
|---|---|
| 320, MMZ D-245.43S2-1380 Stage II |
|
| 320, MMZ D-245.43S2-789 Stage II |
|
| 320C, MMZ D-245.43S3A Stage IIIA |
|
| 320CE, Deutz TD 2012 L04 2Vm Stage IIIA |
|
| 320E, Deutz TD 2012 L04 2Vm Stage IIIA |
|
Additional Notes
- Across all five configurations of the Amkodor Wheeled loaders listed for 2012, the hydraulic brake system brake fluid capacity is uniformly 0.5 liter, which is a relatively small volume consistent with a sealed hydraulic brake circuit rather than a large-reservoir wet brake arrangement.
- The 0.5 liter figure represents a service fill capacity, meaning the amount of fluid required to replenish or refill the hydraulic brake system during a fluid change, not a full overhaul or system-flush volume.
- All five configurations share an identical change interval of 2000 hours under normal use conditions, applying equally to the MMZ-engined variants (320 and 320C) and the Deutz-engined variants (320CE and 320E).
- The 320 variant is listed with two distinct MMZ D-245.43S2 engine designations, specifically the -1380 Stage II and the -789 Stage II, yet both share the same 0.5 liter capacity and 2000-hour change interval for the hydraulic brake system.
- The 320C uses an MMZ D-245.43S3A Stage IIIA engine, representing a higher emissions stage than the Stage II engines fitted to the base 320 variants, while the brake fluid capacity and interval remain at 0.5 liter and 2000 hours respectively.
- The 320CE and 320E both use the Deutz TD 2012 L04 2Vm Stage IIIA engine, differing from the MMZ-powered models in engine origin, yet the hydraulic brake system specifications are identical at 0.5 liter capacity and a 2000-hour change interval.