Renault Scénic III, J95 (EU)

Automatic transmission fluid capacity & service interval

Renault Scénic III, J95 (EU) automatic transmission fluid has a capacity range of 1,7 to 7,6 liters. The data covers 3 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Scénic III 1.5 dCi 110 (2009-2016)
  • Use: Normal
  • Capacity 1,7 liter
  • Code: DC4 6/1
Scénic III 1.5 dCi 110 DPF (2009-2016)
  • Use: Normal
  • Capacity 1,7 liter
  • Code: DC4 6/1
Scénic III 2.0 dCi 150 DPF (2009-2016)
  • Use: Normal
  • Capacity 7,6 liter (Dry fill)
  • Capacity 3,5 liter (Service fill)
  • Code: AJ0 6/1

Additional Notes

  • The Renault Scénic III J95 1.5 dCi 110 and 1.5 dCi 110 DPF share an identical automatic transmission fluid capacity of 1.7 liters, both under normal use conditions and both using a transaxle, semi-automatic unit.
  • The 2.0 dCi 150 DPF carries a dry fill capacity of 7.6 liters, which represents the total fluid volume required when filling a fully drained or rebuilt transmission from empty.
  • A service fill capacity of 3.5 liters applies to the 2.0 dCi 150 DPF transaxle automatic, reflecting the smaller volume needed during a routine fluid change where residual fluid remains in the torque converter and passages.
  • The difference between the 7.6-liter dry fill and the 3.5-liter service fill on the 2.0 dCi 150 DPF indicates that roughly 4.1 liters of fluid is retained within the transmission assembly during a standard drain procedure.
  • The 1.5 dCi 110 and 1.5 dCi 110 DPF variants list only a single capacity figure of 1.7 liters, consistent with the simpler fluid volume characteristics of a semi-automatic transaxle compared to a fully automatic unit.
  • All three configurations across the 2009-2016 model range carry a normal use condition designation, meaning the listed capacities and intervals apply to standard operating environments rather than severe or demanding duty cycles.

Other Systems