Jeep Wrangler, JL (USA / CAN)

Manual transmission fluid capacity & service interval

Jeep Wrangler, JL (USA / CAN) manual transmission fluid capacity is 2,25 liters. The service interval is 30000 miles or 36 months. The data covers 4 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
Wrangler 3.6 eTorque (2019- )
  • Use: Normal
  • Capacity 2,25 liter (Dry fill)
  • Code: AL6 6/1
Wrangler 3.6 eTorque (2019- )
  • Use: Severe
  • Capacity 2,25 liter (Dry fill)
  • Change 30000 miles/ 36 months
  • Code: AL6 6/1
Wrangler 3.6 (2017- )
  • Use: Normal
  • Capacity 2,25 liter (Dry fill)
  • Code: AL6 6/1
Wrangler 3.6 (2017- )
  • Use: Severe
  • Capacity 2,25 liter (Dry fill)
  • Change 30000 miles/ 36 months
  • Code: AL6 6/1

Additional Notes

  • The Jeep Wrangler JL 3.6 and 3.6 eTorque share an identical manual transmission dry fill capacity of 2.25 liters, meaning both engine variants require the same fluid volume when filling a fully drained or rebuilt unit.
  • A dry fill figure represents the total fluid volume a transmission holds from a completely empty state, which typically applies during overhaul or initial factory fill rather than a routine drain-and-refill service.
  • Under normal use conditions, neither the 3.6 nor the 3.6 eTorque configuration carries a listed change interval for manual transmission fluid, while severe use conditions on both variants specify a change at 30,000 miles or 36 months, whichever comes first.
  • The 30,000-mile or 36-month interval tied to severe use on both configurations reflects a time-or-distance threshold, meaning whichever limit is reached first would trigger a fluid change under those operating conditions.
  • The 3.6 eTorque variant entered the specifications starting from 2019, while the standard 3.6 carries a starting year of 2017, placing both within the 2017-2019 scope but with the eTorque applying only to the later portion of that range.

Other Systems