DS DS 3, U

Manual transmission fluid capacity & service interval

DS 3, U manual transmission fluid capacity ranges from 1,7 to 1,8 liters. 1 configuration is covered.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
DS 3 1.2 PureTech 100, HNE, HPV (2022- )
  • Use: Normal
  • Capacity 1,8 liter (Dry fill)
  • Capacity 1,7 liter (Service fill)
  • Code: MB6 6/1

Additional Notes

  • The DS 3 1.2 PureTech 100 (HNE, HPV) transaxle carries a dry fill capacity of 1.8 liters, which represents the total volume required when filling a completely empty or overhauled unit from scratch.
  • A service fill capacity of 1.7 liters applies to the same manual transaxle, reflecting the slightly lower volume needed during a routine fluid change where residual fluid remains in the unit after draining.
  • The 0.1-liter difference between the dry fill and service fill figures on the DS 3 1.2 PureTech 100 manual transaxle is a standard characteristic of partial-drain service procedures, where not all fluid is recovered during a conventional drain.
  • The fluid capacity specifications for the DS 3 1.2 PureTech 100 manual transaxle are listed under normal use conditions, meaning the associated fill volumes correspond to standard operating environments rather than severe-duty cycles.

Other Systems