Cupra León, KL1

Transfer case fluid capacity & service interval

The Cupra León KL1 uses transfer case fluid with a capacity ranging from 0.75 to 0.85 liter depending on the configuration. The data covers 3 different configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • León 2.0 TFSI VZ (228 kW) 4Drive PF (2021- )
  • Bevel gear
  • Use: Normal
  • Capacity 0,75 liter
  • León 2.0 TFSI VZ (245 kW) 4Drive PF (2021- )
  • Bevel gear
  • Use: Normal
  • Capacity 0,85 liter
  • León 2.0 TDI (110 kW) 4Drive DPF (2020- )
  • Bevel gear
  • Use: Normal
  • Capacity 0,75 liter

Additional Notes

  • The Cupra León KL1 transfer case fluid capacity is recorded for three powertrain configurations, all identified specifically as bevel gear transferbox units.
  • The 2.0 TDI (110 kW) 4Drive and the 2.0 TFSI VZ (228 kW) 4Drive share an identical transfer case fluid capacity of 0.75 liter under normal use conditions.
  • The 2.0 TFSI VZ (245 kW) 4Drive carries a slightly higher transfer case fluid capacity of 0.85 liter under normal use conditions, representing a 0.10 liter difference compared to the lower-output TFSI variant.
  • A capacity figure in this context reflects a service fill volume for the bevel gear transferbox, meaning the amount of fluid required when servicing the unit rather than a full overhaul or dry-fill scenario.
  • All three configurations apply the stated capacity values under normal use conditions, which in fluid service terminology generally refers to standard on-road driving as opposed to severe or demanding operating environments.
  • The 2.0 TDI (110 kW) 4Drive entry carries a starting year of 2020, while both TFSI VZ variants are associated with a starting year of 2021, placing the diesel configuration as the earlier introduction within the KL1 generation.

Other Systems