BMW X2, U10 (USA)

Automatic transmission fluid capacity & service interval

BMW X2, U10 (USA) models utilize automatic transmission fluid with a capacity range of 3,95 to 5,5 liters. Service intervals are flexible based on the on board maintenance system. The data covers 1 configuration.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
X2 M35i xDrive (2024- )
  • Use: Flexible (on board maintenance system)
  • Capacity 4,8-5,5 liter (Initial fill)
  • Capacity 3,95-4,6 liter (Service fill)
  • Code: Getrag 7DCT300TUE/ 7DCT400/ 7HDT400 7/1

Additional Notes

  • The BMW X2 M35i xDrive (U10) carries an initial fill capacity of 4.8–5.5 liters for its semi-automatic transaxle, a range that reflects the total fluid volume required when the unit is completely dry, such as during a full overhaul or new assembly.
  • The service fill capacity of 3.95–4.6 liters is notably lower than the initial fill, which is consistent with partial drain procedures where residual fluid remains in the torque converter or valve body after a standard drain.
  • Both the initial and service fill figures are expressed as ranges rather than fixed values, indicating that the precise quantity depends on factors such as fluid temperature at fill time and the degree of drainage achieved during the service procedure.
  • The X2 M35i xDrive (U10) uses a flexible service interval governed by the on-board maintenance system rather than a fixed mileage or time schedule, meaning the transmission fluid change interval is calculated dynamically based on operating conditions detected by the vehicle's sensors.

Other Systems