Valtra (Valmet) M series

Differential fluid capacity & service interval

Valtra (Valmet) M series differential fluid capacity ranges from 6 to 8 liters. Service intervals include checks at 500 hours and changes at 1000 hours or 12 months. The data covers 5 configurations.

The configuration chart below lists fill volumes and service intervals for each engine and trim variant.

TypeSpecifications
  • M120 (2003-2009)
  • Front
  • Use: Normal
  • Capacity 6 liter (Industrial)
  • Capacity 8 liter (Standard)
  • Check 500 hours
  • Change 1000 hours/ 12 months
  • M130 (2003-2009)
  • Front
  • Use: Normal
  • Capacity 6 liter (Industrial)
  • Capacity 8 liter (Standard)
  • Check 500 hours
  • Change 1000 hours/ 12 months
  • M150 (2003-2009)
  • Front
  • Use: Normal
  • Capacity 6 liter (Industrial)
  • Capacity 8 liter (Standard)
  • Check 500 hours
  • Change 1000 hours/ 12 months
  • XM130 (2003-2009)
  • Front
  • Use: Normal
  • Capacity 6 liter (Industrial)
  • Capacity 8 liter (Standard)
  • Check 500 hours
  • Change 1000 hours/ 12 months
  • XM150 (2003-2009)
  • Front
  • Use: Normal
  • Capacity 6 liter (Industrial)
  • Capacity 8 liter (Standard)
  • Check 500 hours
  • Change 1000 hours/ 12 months

Additional Notes

  • The Valtra (Valmet) M series front differential carries two distinct capacity figures depending on axle configuration: 6 liters for the Industrial variant and 8 liters for the Standard variant. The 2-liter difference between the two reflects a physically larger housing in the Standard axle rather than a difference in service procedure.
  • All five M series variants covered here, the M120, M130, M150, XM130, and XM150, share identical front differential fluid capacities across both axle types, meaning no capacity variation exists between model designations within the 2003-2009 production span.
  • The fluid check interval is set at 500 hours under normal use conditions. A mid-interval check at 500 hours serves as a level verification point rather than a full drain-and-fill service.
  • The full fluid change interval is specified at 1000 hours or 12 months, whichever comes first, under normal use conditions. The dual-trigger format means calendar time can mandate a change even when the hour threshold has not been reached, which is relevant for tractors operating at low annual hours.
  • The check interval at 500 hours falls exactly at the halfway point of the 1000-hour change interval, placing a level inspection at the midpoint of each full service cycle for all M series front differential applications listed here.

Other Systems